Ventilation; Installation; General; Standalone Installation - Dataton WATCHPAX 30 User Manual

• Unplug this product from the aC power supply before cleaning. do not use liquid or aerosol clean-
ers on the product. Use a microfiber cloth for cleaning.
• after storage in cold conditions, let the product adapt to normal temperature for two hours before
powering on.

VENTILATION

airflow is critical for the correct operation of WatCHpaX 30. do not stack units or place any items on
top of the WatCHpaX 30.
In any installation, there should always be a minimum of 200 mm clear space at front and 200 mm
above the unit.

INSTALLATION

GENERAL

• this equipment is for professional use for installation at locations where only adults are normally
present. Check the "safety First"
• the WatCHoUt 30 must be connected to a properly grounded wall socket (a socket-outlet with
protective earth connection in the building).
• the serial number is located on the base of the unit.
IMportant: only use the power cord supplied with the WatCHpaX 30 unit, otherwise dataton aB
cannot guarantee full functionality.

STANDALONE INSTALLATION

place the unit flat on its base. the base is the side of the unit showing the serial number and dataton
logo.
InstallatIon and operatIon
Air outlet on top of unit. Do not block.
Keep a minimum 200 mm clear space above the unit.
Air inlet at front of unit. Do not block.
Keep a minimum 200 mm clear space at front of unit.
list before use.
10