Configuring The Transmitters For Your Tourguide Application; Matching The Transmitter To The Receiver; Configuring The Mobile Sk, Skm And Skp Transmitters; Configuring The Stationary Sr Monitoring Transmitter - Sennheiser EK 1039 Instruction Manual

Configuring the transmitters for your Tourguide application

SKM
SKP
-30
-40
SR PEAK B.Ch: 20.24 ew300IEM
Stereo Transmitter 0
-10 531.375 MHz
-20
EQ
-30 -30
-40 -40 Standard -18dB
AF I AF AF II AF II
Stereo Transmitter SR 2000 IEM
B.Ch: 1 1 **2050** Stereo Transmitter SR 2050 IEM
516.000
MHz
EQ
Standard -18dB
22 |
Tourguide 1039
Configuring the transmitters for your
Tourguide application
Please also read the instruction manual for your transmitter. It provides important
information that ensures safe and optimum operation of the transmitter in your
Tourguide application.

Matching the transmitter to the receiver

To be able to establish a transmission link, the transmitter and receiver
used must operate in compatible frequency ranges (see page 4) and must
be set to the same frequency.
Make sure that the desired frequencies are approved and legal in your
country and, if necessary, apply for an operating license.
You can contact your Sennheiser partner who will be pleased to calculate
intermodulation-free frequencies for you or to help you apply for an oper-
ating license.
The receiver's channels have been factory-preset to receiving frequencies that are
intermodulation-free (see frequency table on page 27). However, you can change
the factory-preset frequencies. Within one frequency range, up to 32 transmission
links can be operated simultaneously.
Make sure to set the transmitter of the evolution wireless G3 or 2000 series to
the same frequency as the receiver.
If you still cannot establish a transmission link between transmitter and receiver,
read the chapter "If a problem occurs ..." on page 23.

Configuring the mobile SK, SKM and SKP transmitters

1. Set the frequency that you want to use for your Tourguide application ("Tune"
menu item).
2. Adjust the input sensitivity of the microphone ("Sensitivity" menu item; for
presentation applications, the guide values range from approx. –21 dB to
0 dB).
SK

Configuring the stationary SR monitoring transmitter

1. Set the frequency that you want to use for your Tourguide application ("Tune"
SR 300 IEM
menu item).
2. Set the transmitter to mono operation to avoid interference during RF trans-
B.Ch: 1 1
**2000**
516.000 MHz
EQ
Standard -18dB
mission ("Mode" menu item).
3. Adjust the input sensitivity of the transmitter ("Sensitivity" menu item; for
B.Ch: 1 1 **2050**
516.000 MHz
EQ
Standard -18dB
presentation applications, the guide values range from approx. –21 dB to
0 dB).