(802500) ARB ALTITUDE ROOF TOP TENT
THIS DOCUMENT IS TO BE GIVEN TO OWNER
Vehicle accessories which are not properly fitted can be dangerous.
Please read all instructions carefully prior to using, and comply with the instructions at all times
If in any doubt please contact your nearest ARB state office or the stockist from whom it was
purchased.
Refer to individual Fitting Instructions for fitment to your vehicle
This product or its fixing must not be modified in any way.
The installation of this product may require the use of specialized tools and/or techniques
It is recommended that this product is only installed by trained personnel
Lifting of the tent should be at the f corners from the base or by lifting at the ladder support rails.
DO NOT lift the tent by its top roof bars.
During installation, it is the duty of the installer to check correct operation/clearances of all
components
Work safely at all times
Unless otherwise instructed, tighten all fasteners to specified torque
Check bolt torque after 500km & at regular service intervals
It is recommended that the tent is opened and tested prior to installation and the Ladder and
Mattress removed to facilitate installation.
42-44 Garden St
Kilsyth, Victoria
AUSTRALIA 3137
Australian enquiries
North & South American enquiries
Other international enquiries
19/10/2023
If you have any queries regarding the installation of this product, please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190
OWNER'S MANUAL
PLEASE NOTE THE FOLLOWING:
ARB 4x4 ACCESSORIES
Corporate Head Office
www.arb.com.au
Page 1 of 22
Tel: +61 (3) 9761 6622
Fax: +61 (3) 9761 6807
sales@arb.com.au
sales@arbusa.com
exports@arb.com.au
ARB Copyright 2023
37801296
Need help?
Do you have a question about the 802500 and is the answer not in the manual?
Questions and answers