Bosch HGVDF0V52S User Manual And Installation Instructions page 37

For ovens – converting the appliance from
natural gas to liquid gas
If the appliance was set to natural gas at the time of
delivery (factory setting) (NG: G20, G25) and is now
being converted to liquid gas for the first time (LPG:
G30, G31):
Tighten all of the bypass nozzles in the appliance
1.
clockwise to the limit stop. You can find additional
information about this in the section entitled
→ "Removing the control panel", Page 37.
Then carry out the steps described in the section
2.
entitled
→ "Setting the bypass nozzles", Page 38.
Then carry out the steps described in the section
3.
entitled
→ "Fitting the control panel", Page 38.
Converting the appliance from liquid gas to
natural gas
If you convert the appliance from liquid gas
(LPG: G30, G31) to natural gas (NG: G20, G25) or if
you already carried out this conversion and then undo
this:
Turn all of the bypass nozzles in the appliance anti-
1.
clockwise by 1/2 rotation for the setting. You can
find additional information about this in the section
entitled
→ "Removing the control panel", Page 37.
2. Then carry out the steps described in the section
entitled
→ "Setting the bypass nozzles", Page 38.
Then carry out the steps described in the section
3.
entitled
→ "Fitting the control panel", Page 38.
Removing the control panel
Remove the pan support grids or the pan support
1.
racks and the burner parts.
If burner connection screws are present on the hob,
2.
remove all of these.
Undo the hob panel at the burner hub and lift it up.
3.
Pull the hob panel forwards.
‒
4. Remove the knobs on the front panel by pulling
them towards you.
Remove the screws from the corners of the front
5.
panel.
Remove the screws that become visible after you re-
6.
move the knobs from the front panel.
Installation instructions en
37