Common Issues - SNEED Coding Solutions SNEED PACK CS-5OSB User Manual

Common Issues

Issue
Tape does not cut
The tape has been cut but only
applied to a section of the case/
carton
The box is sealed but the flaps
are loose
The carton gets stuck halfway
through
The tape is retracting or coming
loose from the rollers
www.sneedcoding.com
Cause
The tape head blade is dull or
jammed
The Tape head is likely jammed
1.The main tension spring is too
loose
2.the height adjustment is set
too high.
The main tension springs are
too tight causing the tape
applicators to pinch the box in
place
Check to see if the one-way
tape roller is spinning both
ways.
11
| (833)926-3464
Solution
1.Remove the tape jam.
2.Wipe clean any accumulated
adhesive from the tape head
with 90% isopropyl alcohol.
3.Sharpen or replace the tape
blade.
1.Remove the Jam
2.Check to see if any parts of
the tape head have come loose.
1.Tighten the nut on the tension
rod. This will stiffen the tape
applicators (pg10 / fig7)
Loosen the tension spring by
backing out the nut on the
tension rod (Pg10/Fig 7)
Replace if needed
| support@sneedcoding.com