Table of Contents
Advertisement
5.
OPERATION
5.1.
CONTROL PANEL & DISPLAY
1
POWER
2
MODE
between cool, dry, fan and heat.
3
MODE
indicator
and heat.
4
SLEEP
5
DOWN
timer settings.
6
SWING
NOTE: the above functions can also be performed on the remote control (fig.6).
5.2.
START-UP & SHUTDOWN
5.2.1. Press POWER to turn the unit on. The unit runs in FAN as default.
5.2.2. Press MODE button to select the desired operation mode.
5.2.3. Press POWER again to turn off the power.
5.3.
OPERATION MODES
The unit has five operation modes: Cool, dehumidify, fan, heat, sleep
5.4.
COOLING
Select the cool mode to lower the temperature in your room.
5.4.1. Press MODE button repeatedly until the LED of COOL operation lights up.
5.4.2. Press Up/Down button to adjust the temperature which is displayed on the screen. The temperature can be
set between 16
C and 32
o
5.4.3. Press SPEED button repeatedly until the desired fan speed indicator lights up.
5.4.4. To control the direction of the air flow horizontally, press the SWING button on.
NOTE: The air conditioner stops if the room temperature is lower than selected temperature.
5.5.
HEATING
5.5.1. Press MODE button repeatedly until the LED of HEAT operation lights up.
5.5.2. Press ADD/MINUS button to set the temperature higher than the room temperature. The fan speed can
also be set.
5.6.
VENTILATING
5.6.1. Press MODE button repeatedly until the LED of FAN operation lights up. In ventilation mode the room air is circulated, but not cooled.
5.6.2. Press SPEED button repeatedly to select the fan speed as desired.
5.7.
DRYING/DEHUMIDIFYING YOUR ROOM
5.7.1. Press MODE button on the control panel or remote control, the LED of DRY operation lights up.
5.7.2. The drainage hose should be attached to the unit for continuous operation.
NOTE: In this mode, the fan speed switches over to low speed and the temperature cannot be selected.
5.8.
SLEEP MODE
The sleep mode can be activated when in cool mode and heat mode.
5.8.1. In cool mode:
After 1 hour the preset temperature is increased by 1
5.8.2. In heat mode:
After 1 hour the preset temperature is decreased by 1
The temperature is then kept constant for 10 hours and all indicators dim. The fan speed will switch over to low speed for silent
operation, and cannot be selected.
© Jack Sealey Limited
Press to switch the machine on or off.
Press to switch the operation mode
Indicates the MODE setting - cool, dry, fan
Press to turn sleep mode on or off.
Decrease the desired temperature or
Adjust the air flow direction vertically.
C.
o
Original Language Version
7
SPEED
8
SPEED
indicator
9
TIMER
10 UP
11
DIGITAL
DISPLAY
C, after another hour the preset temperature will again be increased by 1
o
C, after another hour the preset temperature will again be decreased by 1
o
Press to switch the fan speed from high,
medium and low speed.
Indicates the SPEED setting - high,
medium low.
Sets a time for the unit to automatically
start or stop.
Increase the desired temperature (16-
32
C)
o
Displays timer setting and temperature.
FIG.6
SAC12000.V5
Issue 2 (5)
C.
o
C.
o
11/01/24
Advertisement
Table of Contents
