Advertisement
fi g.3
5.3.
WINDOW KIT ASSEMBLY
fi g.5
5.3.1.
Locate window kit locking bracket's threaded shaft through hole in window kit part B (fi g.5).
5.3.2.
Attach washer and wing nut to threaded shaft (fi g.5).
5.3.3.
Slide window kit part A into part B (fi g 6) and locate locking bracket plate into central slot on part A (fi g.5).
5.3.4.
Extend the adjustable window kit to suit the size of the window and tighten the wing nut (fi g.5) to lock.
5.3.5.
Attach exhaust hose assembly, see section 5.2, to window kit part B (fi g.6).
5.4.
ATTACH WINDOW KIT ASSEMBLY
fi g.7
5.4.1.
Open the window and place the window kit into position, then close the window onto the window kit (fi g.7).
NOTE: To obtain maximum efficiency it is recommended that any gaps between the window kit and the sides of the window are
sealed.
5.4.2.
Attach the hose connector on the hose assembly to the exhaust outlet (fi g.1 #7) by sliding the it horizontally into position (fi g.8).
5.4.3.
Place the appliance near to a suitable electrical power outlet and adjust the fl exible exhaust hose to suit, avoiding any sharp bends
to the hose (fi g.9).
5.4.4.
Adjust the louvre panel (fi g.1 #2) to suit (fi g.9).
6. OPERATION
6.1.
CONTROL PANEL AND DISPLAY
fi g.10
© Jack Sealey Limited
1
LOCK
2
MODE
3
UP
4
POWER
5
DOWN
6
SPEED
7
TIMER
8
FAN SPEED
INDICATOR
9
DIGITAL
DISPLAY
10
MODE
INDICATOR
Original Language Version
fi g.8
Press to turn ON or OFF the child lock function
Press to switch operation mode between cooling,
dehumidifier and fan
Increase temperature (16ºC~32ºC) or timer setting
Press to turn the unit ON or OFF
Decreasing the temperature or timer setting
Press to switch the fan speed between HIGH or LOW
Sets a time for the unit to automatically START or STOP
Displays HIGH or LOW fan speed
Displays timer setting and room temperature
Mode display between Cooling, Dehumidifying and Fan
SAC9002.V2 Issue 1 24/01/22
fi g.4
fi g.6
fi g.9
Advertisement
