Sealey SAC7000.V2 Manual

Sealey SAC7000.V2 Manual

7,000, 9000 btu/hr portable air conditioner/dehumidifier/air cooler, window sealing kit

Advertisement

Quick Links

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Do not cover
instructions
1. SAFETY
1.1.
ELECTRICAL SAFETY
WARNING! It is the responsibility of the owner and the operator to read, understand and comply with the following:
You must check all electrical products, before use, to ensure that they are safe. You must inspect power cables, plugs, sockets
and any other connectors for wear or damage. You must ensure that the risk of electric shock is minimised by the installation of
appropriate safety devices. A Residual Current Circuit Breaker (RCCB) should be incorporated in the main distribution board. You
must also read and understand the following instructions concerning electrical safety.
Ensure that cables are always protected against short circuit and overload.
9
Regularly inspect power supply cables and plugs for wear or damage and check all connections
9
to ensure that none are loose.
Ensure that the voltage marked on the appliance matches the power supply to be
9
used and that the plug is fitted with the correct fuse - see fuse rating at right.
DO NOT use worn or damaged cables, plugs or connectors. Have any faulty item repaired or
8
replaced immediately by a competent electrician.
It is recommended that this device is wired directly to a fused isolator switch. If, however, a plug
9
is fitted, the following applies:
Fit a new plug according to the following instructions (UK only).
9
a) Connect the GREEN/YELLOW earth wire to the earth terminal 'E'.
b) Connect the BROWN live wire to the live terminal 'L'.
c) Connect the BLUE neutral wire to the neutral terminal 'N'.
d) After wiring, check that there are no bare wires, that all wires have been correctly connected,
that the cable restraint is tight.
1.2.
GENERAL SAFETY
Check that the unit is in sound condition and good working order. Take immediate action to repair or replace damaged parts.
9
Use recommended parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
NOTE: The appliance is designed for use with propane gas R290 only as it's designated refrigerant.
WARNING: The refrigerant loop is sealed. Servicing should only be carried out by a qualified technician.
DO NOT discharge the refrigerant into the atmosphere.
8
NOTE: Only install or operate in a room with a floor area exceeding 7m
DO NOT attempt any repairs or maintenance unless suitably qualified.
8
DO NOT stand or place any object closer than 500mm (20 inches) from the unit.
8
DO NOT obstruct the air intakes or outlets of the unit.
8
DO NOT cover with items of clothing. DO NOT sit or climb onto the unit.
8
DO NOT place any object into the outlets.
8
DO NOT operate the unit when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT switch the unit off by disconnecting it from the mains. ALWAYS switch it off using the Power button.
8
DO NOT remove the float lever from the water collection tank.
8
DO NOT connect or disconnect the plug from the mains or use the unit with wet hands. Keep the unit dry.
8
DO NOT use the unit outside.
8
DO NOT install or operate this air conditioner in a bathroom or other wet environments.
8
To prevent water from freezing, DO NOT use the unit at ambient temperatures below 0°C.
9
Always discard the water from the collection tank, DO NOT use it for any other purpose.
9
Place the unit on a level and stable surface.
9
If the appliance is tipped at an angle greater than 45°, leave it to stand for at least 24 hours before use.
9
Ensure that heating appliances are not exposed to the flow of air from the unit.
9
Before attempting to move the unit, empty the contents of the water tank. Use carrying handle (fig1.3) when moving unit.
9
Switch off and disconnect unit from the mains before attempting any cleaning or other maintenance work.
9
Ensure that the unit is turned off correctly when not in use, and stored in a safe, dry area, out of reach of children.
9
NOTE: This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of
the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.
© Jack Sealey Limited
7,000, 9000 BTU/HR PORTABLE AIR CONDITIONER/
DEHUMIDIFIER/AIR COOLER, WINDOW SEALING KIT
SAC7000.V2, SAC9002.V3, SACWK1
MODEL NO:
Indoor use
Caution:
only
risk of fire
Original Language Version
.
2
SAC7000.V2, SCS9002.V3,SACWK1 Issue 1 05/01/23
Recommended fuse rating
13 Amp

Advertisement

Table of Contents
loading

Summary of Contents for Sealey SAC7000.V2

  • Page 1 SAC7000.V2, SAC9002.V3, SACWK1 MODEL NO: Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
  • Page 2: Specification

    Washable filter. Auto-defrost function at low ambient temperature. Mounted on castor wheels for manoeuvrability. 3. SPECIFICATION Model No.: ............SAC9000.V3 Model No.: ............SAC7000.V2 Cooling Capacity: ..........9000Btu/hr Cooling Capacity: ..........7000Btu/hr Discharge Side Pressure: ..........3.2MPa Discharge Side Pressure: ..........3.2MPa Energy Rating: ............ A (EER:2.6) Energy Rating: ............ A (EER:2.6) IP Rating: ............... IPX1 IP Rating: ...............
  • Page 3: Operation

    Sets a time for the unit to automatically START or STOP FAN SPEED Displays HIGH or LOW fan speed INDICATOR DIGITAL Displays timer setting and room temperature DISPLAY MODE Mode display between Cooling, Dehumidifying and Fan INDICATOR fig.10 6.1.1. The display on the front face of the unit will only light when the unit is in cooling mode. SAC7000.V2, SCS9002.V3,SACWK1 Issue 1 05/01/23 Original Language Version © Jack Sealey Limited...
  • Page 4: Operation Mode

    When the unit has completely drained replace the drain plug back fully into the drainage hole. NOTE: To assist with drainage the unit can be slightly tilted backwards to allow the drain plug to be re-inserted if the container becomes full. 6.5.5. Replace the electric plug into the power source and re-start the appliance in the desired mode. WARNING! Ensure that the drain plug is fully inserted, otherwise the condensate water will flow ‰ out onto the floor. fig.12 SAC7000.V2, SCS9002.V3,SACWK1 Issue 1 05/01/23 Original Language Version © Jack Sealey Limited...
  • Page 5: Maintenance

    NOTE: The condensate water will automatically flow into the container or drain. 7. MAINTENANCE NOTE: Maintenance, service and repair must be carried out by qualified person. Contact your Sealey stockist for details. 7.1. CLEANING 7.1.1.
  • Page 6 If you want to close your window, simply detach the cloth from the Velcro tape. When closing the window take care that the seal is not jammed between the casement and window frame. NOTE: This window seal ensures that the room remains cool for a longer period of time and keeps insects and mosquitoes out. SAC7000.V2, SCS9002.V3,SACWK1 Issue 1 05/01/23 Original Language Version © Jack Sealey Limited...
  • Page 7 POLYESTER MATERIAL fig.1 M = MIDDLE OPEN WINDOW fig.2 fig.4 fig.3 OPEN SKYLIGHT TILTED WINDOW fig.6 fig.5 13.9. The installed item will resemble fig.5 and fig.6. SAC7000.V2, SCS9002.V3,SACWK1 Issue 1 05/01/23 Original Language Version © Jack Sealey Limited...
  • Page 8: Environment Protection

    BATTERY REMOVAL: REMOVE BATTERY FROM REMOTE Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack Sealey Ltd Batteries Producer Registration Number (BPRN) is BPRN00705.

This manual is also suitable for:

Sac9002.v3Sacwk1

Table of Contents