Advertisement
Quick Links
RESOLUTION DIAGRAM
F-8
M8-3
HM-11
HM-12
HM-8
HM-9
HM-13
WARRANTY PARTS
F-1
:
Coupling (Right)
F-2
:
Coupling (Left)
F-4
:
Coupling Cover
F-7
:
Hub Handle
F-8
:
Left Knob Bolt
HF-3 :
HyperMag Main Frame
M8-3 :
Rubber Frame Cap
M8-4 :
Rubber Foot Cap (35mm)
All manuals and user guides at all-guides.com
HyperMag-1200-LW indoor bicycle trainer
F-4
HF-3
HM-2
M8-4
HM-2 :
HM-3 :
HM-5 :
HM-7 :
HM-8 :
HM-9 :
HM-11:
HM-12:
HM-13:
LM-13:
- 1 -
F-4
F-2
F-1
M8-3
HM-3
LM-13
Flywheel Side Inner Case
Mag Side Inner Case
Remote Outer Cover
Alloy Rotor
Axle w/ Bearings
Connection Plate
Flywheel Cover (yellow)
Flywheel (1,200g)
Base Plate
Foot Pedal
F-7
M8-4
HM-7
HM-5
Advertisement
Related Manuals for MINOURA HyperMag-1200-LW
Summary of Contents for MINOURA HyperMag-1200-LW
- Page 1 All manuals and user guides at all-guides.com HyperMag-1200-LW indoor bicycle trainer RESOLUTION DIAGRAM HF-3 M8-3 M8-4 HM-11 HM-12 HM-2 M8-3 M8-4 HM-3 HM-7 HM-5 HM-8 HM-9 HM-13 LM-13 WARRANTY PARTS Coupling (Right) HM-2 : Flywheel Side Inner Case Coupling (Left)
-
Page 2: Important Notes
• "Magturbo" is the trademarks of Minoura Co.,Ltd. and may not be copied. • "Magturbo" is the trademarks of Minoura Co.,Ltd. and may not be copied. • "Magturbo" is the trademarks of Minoura Co.,Ltd. and may not be copied. - Page 3 All manuals and user guides at all-guides.com How To Setup Your HyperMag1200 Trainer Open the frame support legs and fit the rubber feet at the correct angle so the base is in full contact with the floor. Do NOT remove the round metal plates from inside the rubber feet when fitting. NOTE: If the both legs don’t touch the floor at same time and if one side of the leg is still being lifted up slightly, pull up the leg upward strongly then place the trainer on the floor again.
- Page 4 All manuals and user guides at all-guides.com Increasing Load Force Increasing Load Force Increasing Load Force Increasing Load Force Increasing Load Force To increase the load force, turn the lever on your thumb shifter device toward the “H” symbol. (see Fig. E) Decreasing Load Force Decreasing Load Force Decreasing Load Force...
- Page 5 UK DISTRIBUTOR : ZYRO PLC UK DISTRIBUTOR : ZYRO PLC Becklands Close, Bar Lane, Roecliffe, York Y05 9LS, U.K. Phone 01423-325325 / Fax 01423-323111 Email: zyro@zyro.co.uk http://www.zyro.eu.com Made & Quality Controlled in Japan - 5 - Copyright © 2003 Minoura Japan, All Rights Reserved.
Need help?
Do you have a question about the HyperMag-1200-LW and is the answer not in the manual?
Questions and answers