Adjustment
Cloth pressure setting adjustment
1. Attach J presser foot.
2. Start the test mode, and select test mode "02"
3. Turn the pulley by hand until the feed dog is lower than the needle plate.
4. Lower the presser lever, and then press [0] on the screen.
5. Raise the presser lever, and insert a 3 mm gauge.
6. Lower the presser lever, and press [3] on the screen.
7. Raise the presser lever, and remove the 3mm gauge.
8. Lower the press lever, and press [OK] of PF PM Adjust
9. Press [CLOSE].
3mm
4 - 19