Advertisement
Quick Links
Troubleshooting: Mahlkonig E65 GbW
Problem
Cause
• The power
The grinder is
not grinding;
the display
does not
light up.
• The bean con-
• The thermal
• The electric
Remedy
plug is not
plugged into a
socket.
tainer is not
inserted.
overcurrent
circuit-breaker
has been
triggered.
fuse has
tripped.
Insert the power plug into a properly
installed wall socket.
Insert the bean container (see
Instruction Manual, "Se ng up the
grinder and inserting the bean
container" sec on).
Check whether the circuit-breaker's
release bu on has popped out. Push
it back in if necessary. If the circuit-
breaker repeatedly pops out, contact
a service technician for support.
Check the electric fuse. Return it to
its original state or replace it. Check
whether other loads are connected
to this fuse and if so, pull their plugs.
If the fuse trips repeatedly, contact a
service technician for support.
Advertisement
Related Manuals for Mahlkonig E65 GbW
Summary of Contents for Mahlkonig E65 GbW
- Page 1 Troubleshooting: Mahlkonig E65 GbW Problem Cause Remedy • The power Insert the power plug into a properly The grinder is plug is not installed wall socket. not grinding; plugged into a the display socket. does not light up.
- Page 2 Then adjust the grinding degree se· ng to the grinding degree required during operation. Clean the outlet system • Ground coff ee (see Mahlkonig E65S Service & Repair has built up YouTube playlist: "Maintenance in the grinder cleaning"). because of too Release the lock on the grinding much coff...
- Page 3 "Load cell calibration"). permanently red. Clean/change the burrs or adjust • The burrs are The grinder is the burrs (see Mahlkonig E65S GbW worn out or not grinding Service & Repair YouTube playlist: require read- fi ne enough. "Burr replacement".
- Page 4 Replace the spout. • The grinder spout is dam- aged. • The fl apper is Clean the fl apper (see Mahlkonig E65S dirty. GbW Service & Repair YouTube "Maintenance cleaning"). • The fl apper is faulty.
- Page 5 ESPRESSO GRINDER Fault Cause Remedy Align the fixed burr fl ange correctly The grinder • The fi x burr (see “Cleaning the burrs” in the lid cannot be fl ange is not instruction manual). ached. installed cor- rectly. • The adjust- ...
-
Page 6: Maintenance And Service
Maintenance and service In the event of service or maintenance, contact an authorised service technician for Mahlkönig products. A service technician can answer your ques ons about repairing and maintaining your product and spare parts. Enlarged diagrams and informa on on spare parts are also available at: www.mahlkoenig.de www.mahlkoenig.de/retailers...