Setting The Heating To On; Setting The Dhw To On - Samsung AE080BXYDEG Installation And Setup

SETTING THE HEATING
TO ON
1. Using the Left and Right arrow highlight the
zone required
2. Push the Power button to enable.
3. Screen Will display 0.0
4. Push ok and the Flow Temps can be seen
5. Use the return key to exit.
*0.0 must be on for the heat pump to detect a
run signal from the system

SETTING THE DHW TO ON

1. Using the Left and Right arrow highlight the
Domestic Hot Water.
2. Push the Power button to enable.
3. DHW is Displayed.
4. To Set the DHW temp push OK whilst DHW
is highlighted.
5. Use the up and down to set the value.
6. Push the OK button to set mode, this should
be Standard.
7. Use the up and down Keys select standard
and push OK.
8. Use the return key to exit.
9
www.seconrenewables.com 0191 516 6553
info@seconrenewables.com