Protecting The Environment - DeWalt DW735-XE Original Instructions Manual

Hide thumbs Also See for DW735-XE:

Instruction manual (17 pages)

Table Of Contents

Table of Contents

English

•

DW7350 Mobile Stand

•

DW7351 Folding Tables

•

DW7352 325 mm Knives

•

DW7353 Chip Ejection Accessory

nOTE: Helical cutterheads have not been tested with this

product and are not recommended for use.

DW7351 Accessory Folding Tables (Fig. X)

WARNING: For your own safety, read the tool instruction

manual before attaching the tables. Failure to heed

these warnings may result in personal injury and serious

damage to the planer and the accessory. When servicing

this tool, use only identical replace ment parts. Have

damaged cords replaced by an authorized service center.

Your DW7351 folding table box should include:

2 folding tables

4 cap screws

4 springs

Set-Up and Installation of Base Hardware

(Fig. Y, Z)

1. Place planer on a secure table or workbench. Position planer

so the front 75–100 mm (3–4") of the base can be accessed

from the underside.

2. Secure the rear of the planer to the table/bench with nails or

screws to prevent it from tilting or falling from the table.

WARNING: The planer could tilt or fall from the table if it

is not properly secured opposite the end where the folding

table is being installed. Serious injury may result.

3. Place the spring onto the small end of the stepped bolt.

4. Insert the end of the bolt with the spring around it into the

larger hole on the side of the base.

5. Push the stepped bolt all the way through the hole in the

first rib on the underside of the planer. The spring should

engage the rib slightly and the threads should show on the

right side of the rib.

6. On the underside of the planer, use a wrench to hold the

nut in place while turning the stepped bolt into it. The 5/32"

(4 mm) hex wrench can be used to turn the stepped bolt

until it is fully secured (Fig. Y).

7. Install the smaller screw into the lower threaded hole on

the side of the base. Use the 5/32" (4 mm) hex wrench to

tighten that fastener securely.

8. Depress the top pin until it is flush with the base and slide

the top hole of the table over the pin and release the pin so

they lock together (Fig. Z).

9. To attach the table to the rear of the planer, install the bolts

and spring following the above procedure.

Your tables should now fold up and down on the top screw and

rest on the bottom screw while in position for planing.

nOTE: To transport the planer with the tables, fold them up and

carry the unit as recommended by the planer manual.

4 nuts

4 stepped bolts

WARNING: For your own safety, it is recommended

that two people carry this machine or serious injury

could result.

To Remove the Tables

1. Depress the spring-loaded bolts on the base and slide each

end of the table toward you so they disengage the holes

in the tables. You may want to use the T-wrench from your

planer to push the bolts flush with the base to easily remove

the tables.

2. Leave the hardware (stepped bolts and small cap screw) in

the base until you need to re-attach the tables.

Lubrication

Your power tool requires no additional lubrication.