Operating The Control Panel - TEFAL 2930 Instructions For Use Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 23

4- OPERATING THE CONTROL PANEL

• Flashing green light : the water is heating up in the boiler.
• Continuous green light : steam is ready for use.
• Continuous red light : the water tank is empty.
• "Restart" button : boiler reset button to be activated after each refill (see chapter 6)
5- USING YOUR STEAM GENERATOR
1. Place the iron's thermostat control to the type of fabric to be ironed
2. The thermostat light comes on.
Be careful ! The steam generator is ready when the thermostat light goes out and when
the green "steam ready" light stays on.
Note : it is normal for the steam cord to become warm during use.
3. Adjust the steam output control dial located on the control panel
4. To obtain steam, press on the steam control button beneath the iron handle and keep it pressed
The steam will stop when you release the button.
Recommendations :
• To prime the steam circuit, either before using the iron for the first time, or if you have not used the
steam function for a few minutes, press the steam control button several times in a row, holding the
iron away from your clothes.
This will enable any cold water to be removed from the steam circuit
Iron thermostat control setting :
• Start with the fabrics to be ironed at a low temperature ( ) and finish with those which need higher
temperatures (
- Mixed fibre fabrics : set the ironing temperature to the setting for the most delicate fabric.
- Woollen garments : press repeatedly on the steam control button to obtain short bursts of steam,
without placing the iron on the garment itself.
Steam output control dial setting :
- Thick fabric : increase the steam setting.
- At a low temperature : set the steam output control dial to the low position.
To iron without using steam :
• Do not press on the steam control button under the iron handle.
Ironing Board :
For best results, a mesh type ironing board should be used to allow any excess steam to escape.
• If you are using starch, it should be sprayed onto the reverse side of the fabric to be ironed.
6
or Max).
7
6
.
7
.
Linen
Cotton
Wool
Silk, Viscose
Synthetics,
Polyester, Acetate,
Acrylic, Polyamide
8
8
.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pro expressPro express turbo

Table of Contents