Using Your Steam Generator - TEFAL 2930 Instructions For Use Manual

2- PREPARING YOUR STEAM GENERATOR
1. Place your steam generator on a stable, horizontal heat-resistant surface.
2. Remove the water tank by pulling the handles upwards
3. Fill up the water tank taking care not to exceed the maximum level just below the filler cover
4. Replace it firmly in its housing, making sure it is fully pushed down
The water to use in your steam generator :
Your steam generator has been designed to operate using tap water. However, if your water is very
hard, mix it 50% tap water with 50% distilled water.
Types of water to be avoided :
Do not add anything to the contents of the removable water tank, and do not use water from
clothes dryers, scented or softened water, water from refrigerators, batteries or air conditioners,
pure distilled water or rain water.These contain organic waste or mineral elements that become
concentrated when heated and cause spitting, brown staining or premature wear to your iron.

3- USING YOUR STEAM GENERATOR

1. Completely unwind the power cord from its storage space before connecting to an earthed socket
2. Press on the on / off switch (located under the cord reel button)
control panel) flashes and the boiler heats up
which is indicated when the green "steam ready" light stops flashing
• The first time the appliance is used, there may be some fumes and smell but this is not
harmful. They will not affect use and will disappear rapidly.
• When starting, and regularly while it is being used, your steam generator's electric pump
injects water into the boiler. It makes a noise but this is quite normal.You may also hear a
clicking noise which is the steam valve opening.Again this is normal. If you are pressing on the
steam control button at this time you may lose a little steam pressure momentarily.
1
.It will take around 2 minutes for steam to be produced
4
.
1
3 .
2
: the green light (located on the
5
.
2
2 .
3
1
5
.
4