Battery Type; Package Contents; Markings On Tool - Stanley FATMAX SFMCM300 Original Instructions Manual

18v cordless cutoff tool
Hide thumbs Also See for FATMAX SFMCM300:
Table of Contents

Advertisement

ENgLiSh
All lithium-ion batteries have the Wh rating marked on the pack.
Furthermore, due to regulation complexities, STANLEY FATMAX
does not recommend air shipping lithium-ion battery packs alone
regardless of Wh rating. Shipments of tools with batteries (combo
kits) can be air shipped as excepted if the Wh rating of the battery
pack is no greater than 100 Wh.
Regardless of whether a shipment is considered excepted
or fully regulated, it is the shipper's responsibility to consult
the latest regulations for packaging, labeling/marking and
documentation requirements.
The information provided in this section of the manual is
provided in good faith and believed to be accurate at the time
the document was created. However, no warranty, expressed or
implied, is given. It is the buyer's responsibility to ensure that its
activities comply with the applicable regulations.
Storage Recommendations
1. The best storage place is one that is cool and dry away from
direct sunlight and excessive heat or cold. For optimum
battery performance and life, store battery packs at room
temperature when not in use.
2. For long storage, it is recommended to store a fully charged
battery pack in a cool, dry place out of the charger for
optimal results.
NOTE: Battery packs should not be stored completely
depleted of charge. The battery pack will need to be recharged
before use.
Labels on Charger and Battery Pack
In addition to the pictographs used in this manual, the
labels on the charger and the battery pack may show the
L
following pictographs:
Read instruction manual before use.
p
Refer to Technical Data for charging time.
q
Do not probe with conductive objects.
r
Do not charge damaged battery packs.
s
Do not expose to water.
t
Have defective cords replaced immediately.
u
Charge only between 4 ˚C and 40 ˚C.
v
Only for indoor use.
x
Discard the battery pack with due care for
the environment.
12
12
y
Charge battery packs only with designated STANLEY
FATMAX chargers. Charging battery packs other than
the designated STANLEY FATMAX batteries with a
STANLEY FATMAX charger may make them burst or
lead to other dangerous situations.
z
Do not incinerate the battery pack.

Battery Type

The following tools operate on an 18 volt battery pack:
SFMCM300.
These battery packs may be used: SFMCB201, SFMCB202,
SFMCB204, SFMCB206. Refer to Technical Data for
more information.

Package Contents

The SFMCM300 package contains:
1 Cutoff Tool
1 Dustport Adaptor
1 76 mm Bonded Reinforced Wheel
1 76 mm Diamond Multi-Material Wheel
1 Arbor Adaptor
1 Hex Wrench
1 Instruction manual
2 Batteries (D2 models only)
1 Charger (D2 models only)
NOTE: Battery packs, chargers and kitboxes are not included
with B models.
Check for damage to the tool, parts or accessories which may
have occurred during transport.
Take the time to thoroughly read and understand this manual
prior to operation.

Markings on Tool

The following pictograms may be shown on the tool:
a
Read instruction manual before use.
g
Wear ear protection.
f
Wear eye protection.
n
Visible radiation. Do not stare into light.
Icon order : Reverse/lock/forward
Date Code Position (Fig. C)
The production date code
by a 2-digit week and is extended by a 2-digit factory code.
 30 
consists of a 4-digit year followed

Advertisement

Table of Contents
loading

Table of Contents