Power On; Power Off - Uniden iGO CAM 45R Owner's Manual

Power On

When connected to a car charger with power, the device will
automatically power on and start recording.
NOTE
1. Ensure the USB Charging Cable is connected to the USB car charger.
2. Plug in the USB car charger to the car's cigarette lighter port.
3. Connect the other end of the USB charging cable into the micro USB port
found on top of the GPS mount bracket.
4. Connect the USB cable from the side of the GPS mount bracket into the
micro USB port found on the device.
5. The device will power on automatically when the car supplies the power to
the device.
6. The red dot on the screen will start flashing and recording starts
automatically.
At other times, press and hold the OK/Power button for at least 2 seconds.
Be sure insert the SD card before powering up the device.
Format the SD card before you start recording for the first time.
NOTE

Power Off

When the car's engine is turned off, the device will automatically turn off in a
few seconds.
At other times, press and hold the OK/Power button for at least 2 seconds to
turn off the device. Do not eject the SD card immediately to prevent damage
to the last recorded file.
If you wish to switch the device back on, press and hold the OK/Power button
for at least 2 seconds.
Only use the USB Car Charger Adaptor and USB Charging
cable that comes with your device. Any other adaptor might
damage the device.
NOTE
UNIDEN iGO CAM 45R
9
Vehicle Recorder