Single-Zone Setting For Long-Term Storage; General Safety Rules; Introduction; Guards - Electrolux WC170BKMZ Installation, Use And Maintenance Instructions

Single-zone setting for long-term storage

For long-term wine storage, the top and bottom sections
should both be set at 12°C.
With identical settings for the top and bottom sections, the
controls will maintain an even temperature throughout the
cabinet.
However, the temperature in the room will gradually affect
the temperature in the cabinet through its door and sides,
creating a slight temperature gradient from top to bottom.
The controls will maintain the set temperature at the bottom
of the cabinet, and any deviation from the setting will there-
fore occur at the top.
The difference will vary from 0 to 3°C, depending on the am-
bient temperature.

General safety rules

Introduction

The machines have electric and/or mechanical safety devices
for protecting workers and the machine itself. Therefore the
user must not remove or tamper with such devices.
The Manufacturer declines any liability for damage due to
tampering or their non-use.

Guards

The guards on the machine are:
fixed guards (e.g. casings, covers, side panels, etc.), fixed
` `
to the machine and/or frame with screws or quick-release
connectors that can only be removed or opened with tools;
interlocked movable guards (door) for access inside the
` `
machine;
machine electrical equipment access doors, made from
` `
hinged panels openable with tools. The door must not
be opened when the machine is connected to the
power supply.
ATTENTION
Several illustrations
the manual show the ma-
chine, or parts of it, with-
out guards or with guards
removed. This is purely for
explanatory purposes. Do
not use the machine with-
out the guards or with the
protection devices deacti-
vated.
36
Safety signs to be placed on the machine or near its area
Prohibition
ATTENTION
Do not remove, tamper
with or make illegible the
safety, danger and instruc-
tion signs and labels on
the machine.

End of use

When the appliance is no longer to be used, make it unusable
by removing the mains power supply wiring.

Instructions for use and maintenance

Risks mainly of a mechanical, thermal and electrical nature
exist in the machine.
Where possible the risks have been neutralised:
directly, by means of adequate design solutions,
` `
indirectly by using guards, protection and safety devices.
` `
Any anomalous situations are signalled on the control panel
display.
During maintenance several risks remain, as these could not
be eliminated, and must be neutralised by adopting specific
measures and precautions.
Do not carry out any checking, cleaning, repair or maintenance
operations on moving parts.
Workers must be informed of this prohibition by means of
clearly visible signs.
To guarantee machine efficiency and correct operation, pe-
riodical maintenance must be carried out according to the
in
instructions given in this manual.
In particular, make sure to periodically check correct operation
of all the safety devices and the insulation of electrical cables,
which must be replaced if damaged.
Meaning
ISO 7010 W021
Flammable refrigerant