Technical Data; Climatic Class; Materials; Dimensions, Performance And Consumption - Electrolux WC170BKMZ Installation, Use And Maintenance Instructions

Technical data

Climatic class:

CC4

Materials:

Refrigerant R600a

Dimensions, performance and consumption.

1. Netto volume 368l.
2. Voltage220-240v
3. Power 200W
4. Current 1A

Transport, handling and storage

Introduction

Transport (i.e. transfer of the machine from one place to anoth-
er) and handling (i.e. transfer inside workplaces) must occur
with the use of special and adequate means.
ATTENTION
Due to their size, the ma-
chines cannot be stacked
on top of each other during
transport, handling and
storage; this eliminates any
risks of loads tipping over
due to stacking.
NOTE
Qualified personnel must:
have specific technical training and experience in
` `
the use of lifting systems;
have knowledge of the safety regulations and ap-
` `
plicable laws in the relevant sector;
have knowledge of the general safety rules;
` `
ensure the use of personal protection equipment
` `
suitable for the type of operation carried out;
be able to recognise and avoid any possible hazard.
` `

Transport: instructions for the carrier

ATTENTION
Do not stand under sus-
pended loads during load-
ing/unloading operations.
Unauthorised personnel
must not enter the work
area.
The weight of the appliance
alone is not sufficient to
keep it steady.
NOTE
The transported load can shift:
when braking;
` `
when accelerating;
` `
in corners;
` `
on rough roads.
` `

Handling

Arrange a suitable area with flat floor for machine unloading
and storage operations.

Procedures for handling operations

For correct and safe lifting operations:
use the type of equipment most suitable for character-
` `
istics and capacity (e.g. electric pallet truck or lift truck);
cover sharp edges;
` `
Before lifting:
send all operators to a safe position and prevent persons
` `
from entering the handling area;
make sure the load is stable;
` `
make sure no material can fall during lifting. Manoeuvre
` `
vertically in order to avoid impacts;
handle the machine, keeping it at minimum height from
` `
the ground.
ATTENTION
For machine lifting and
anchoring, do not use mov-
able or weak parts such
as: casings, electrical race-
ways, pneumatic parts, etc.

Shifting

The operator must:
have a general view of the path to be followed;
` `
stop the manoeuvre in case of hazardous situations.
` `
ATTENTION
Do not push or pull the
appliance to move it, as it
may tip over.
31