Installation; Before Connection; Electrical Connection - Smeg S30AS Instruction Manual

BEFORE CONNECTION

• Make sure that your oven has not suffered any damage during transport (deformed door
or door seal, etc.). If you see any signs of damage, contact your dealer before use.
• Check the power voltage. If there is a PERMANENT undervoltage (200-210 volts), consult your
electrical installer.
LOCATION
• The oven is meant to be set on a work surface at least 85 cm above floor level.
• Place the oven on a flat and horizontal surface, away from any source of heat or
steam. To ensure the stability of the microwave oven, the front left foot
is adjustable (5 positions). Turn it to raise or lower the appliance.
• Make sure that air may circulate freely around the oven.
Leave sufficient space around the oven :
- 5 cm between the sides of the oven
and any walls or objects
- 14 cm above the oven
- 10 cm behind the oven.
• Make sure that nothing obstructs the ventilation
louvers at the back of the appliance.
• Make sure the electrical plug will be accessible after installation.

ELECTRICAL CONNECTION

• Your installation must be protected by a 16 Amp thermal fuse.
• It is mandatory to use a power point with a ground terminal, connected in accordance with
current safety regulations.
• In your electrical installation, provide a device that is accessible to the installer, capable of
separating the appliance from the mains power and whose contact opening is at least 3 mm
at all of the poles.
• Never operate the oven if the supply cord and/ or its plug are damaged. In case of damage,
call in a specialised technician trained by the manufacturer.

Installation

3
14 cm
5 cm
5 cm