Table of Contents
Advertisement
5 - TRANSPORT AND HANDLING
These machines must be unloaded and positioned by a spe-
cialist handling company using the appropriate, standardized
tools.
Important: outdoor module are supplied for building work in-
stallation as split version, and the transport for the modules
must be independent, never pre-assembled.
The unit must be handled with care to avoid transport damage.
Important: Not store the units in the open air.
Before handling, check that:
- The path leading to the installation location is accessible and
free from obstacles.
- The surface to the emplacement has to be larger than
transport pallet.
Discharge via forklift truck
The outdoor module is designed to be transported safely by
using a forklift truck.
The standards and recommendations of the forklift truck must
also be respected with regards to the maximum load, inclina-
tion of the fork carriage, elevation of the load for transport,
and, in particular, the maximum speed.
The forks of the forklift truck must come in on the side of the
unit, ensuring that the center of gravity of the unit remains
within the forks, because a balancing in the transport may
cause the unit to turn over and fall from the forklift truck.
The recommended length for the forks will be bigger than the
unit width, so that the entire weight-bearing structure can be
supported on the forklift truck. This also prevents the possible
introduction of the truck's fork into functional parts of the unit
that may cause damage to the unit.
It is always mandatory to grasp the unit by the points intended
for that purpose. Any handling of the unit by other means or by
gripping points different from those described here may be danger-
ous for both the unit and the personnel who are carrying out the
discharging or transport work.
Always check the weight of the set and verify that the
discharging method used is approved for handling that
weight.
Model
Weight (kg)
38RM-08N
251
38RM-10N
265
38RM-12N
280
38RM-15N
502
38RM-20N
530
38RM-25N
560
Rigging
1. To prevent damage while in transit, do not remove the unit
from the skid until it is at its final location.
2. Never roll or tip the unit more than 15
IMPORTANT: Make sure that all unit panels are fixed in place
before moving. Raise and set down the unit carefully.
Model
Weight (kg)
38RM-30N
1010
38RM-35N
1040
38RM-40N
1070
38RM-45N
1100
38RM-50N
1130
o
6
Advertisement
Table of Contents
