Disposal Of Parts/Materials; Transport And Lifting Instructions; General; Transport And Storage - Carrier AiroVision 39 HQ Installation, Operation And Maintenance Instructions

6
Electrical Voltage
This pictogram indicates that
there are electrical components
behind this access cover, door
or panel that may be dangerous
for the user/installer. Only per-
sonnel qualified in accordance
with EN50110 is permitted to
carry out work on these compo-
nents. The pictogram is attached to the access cover
for the electric heater control box.
Removal of Transport Brackets
This pictogram is located at the bottom of the fan
section. It indicates that the transport brackets must
be removed during commissioning before the fan is
started up.
Central Data
This label contains the data for the AHU, such as
order number, position number etc. If present, the
label is normally located on the access cover or the
door of the fan assembly.
Opening the Fan Door
This pictogram is positioned on the outside of the door
or access cover of the fan assembly. This pictogram
warns that the fan must have been switched off and
deenergised for a minimum of two minutes before
the door or access cover is opened.
Caution: All doors and access covers must be closed
before starting up the AHU.
Unit Matching Label
This label shows that matching surfaces of AHU units
for assembly. It exists at bottom right and left corner of
units. Sample label is as follows.
Lifting and Transport
An instruction is attached to the AHU that describes
the procedures that must be followed for lifting and
transport.The following chapter contains further
details.

1.4. Disposal of Parts/Materials

- The packaging material must be disposed of in a
responsible manner and in accordance with local
regulations.
- Components that are replaced, must be disposed
of as described above.

2. TRANSPORT AND LIFTING INSTRUCTIONS

2.1. General

Transport and lifting of the AHU must always be in
accordance with the instructions below. If these in-
structions are not observed, irreparable damage may
occur to the unit, and people in the immediate vicinity
of the unit are also endangered. Alarko Carrier does
not accept any responsibility if these instructions are
not observed. Transport and lifting must be carried out
by qualified personnel. The AHU must only be lifted
with lifting bars supplied by Alarko Carrier. Lifting must
be carried out in accordance with local regulations
and with the help of certified lifting aids.

2.2. Transport and Storage

Lifting of the AHU is only permitted under the desig-
nated lifting methods. For transporting,
points shall be used. If it is not possible to
marked points due to the loading conditions, trans-
porting from side profiles can only be done by forklift
(cranes cannot be used). This applies to transport as
well as storage, and is indicated on the side profiles by
warning label.
Air Handling Units deliver to the side by sections. Mov-
ing the plastic cover will let the dirt and particulates en-
ter to the unit from openings. Do not move the protection
cover unless you complete the installation of the unit.
marked
u s e