Table of Contents
Advertisement
Instructions for the user
6.3.3 Flame-spreader crowns
For easier cleaning, the flame spreader crowns can be
removed; wash them with warm water and a non-abrasive
detergent making sure to remove any encrustations and wait
until they are perfectly dry.
The burner pins A must be inserted in the housings B in the
burner crown. The holes C in the burner crowns should be slid
over the igniters and thermocouples D on the hob.
DO NOT REMOVE THE FASTENING PLATES TO CLEAN THE HOB.
6.3.4 Igniters and thermocouples
For correct operation the igniters and thermocouples must
always be perfectly clean. Check them frequently and clean
them with a damp cloth if necessary. Remove any dry
residues with a wooden toothpick or a needle.
After cleaning, dry the appliance thoroughly to prevent water or detergent drips
from interfering with its operation or creating unsightly marks.
A
C
B
D
E
43
Advertisement
Table of Contents
