Table of Contents
Advertisement
Command Reference Program
(Using the Setup Disk)
The Command Reference program allows you to access a detailed explanation of each software command on the
screen. Each displayed explanation can be printed out if required.
Before using the Setup Disk, it is recommended that you make a back-up copy and store the original in a safe
place.
Note:
eUse the DISKCOPY command of the operating system to make a back-up copy. Refer to your DOS manual
for further information.
e You may find it convenient to install the Setup Disk programs directly onto your C Drive, rather than reading
them from the Setup Disk each time a change is necessary. Either method is acceptable.
To perform an automatic installation of the Setup Disk files onto your C Drive, refer to page 34.
1
inser your Setup Disk into either drive A or B.
«For DOS»
«For WINDOWS>
2 Type A: (or B:) and press
2 Select
from the File menu.
З Type CMDREF.
З Type A:\CMDREF ( or BACMDREF).
4
Press (Enter).
4
сик
(or press (Enter)).
D
Тһе first screen is an introduction
Screen 1
to the operation of the Setup Disk.
Please read through it and press
any key to continue.
(If your display is monochrome,
[EPSON:
press "М" key.)
EM
<<
Panasonic KX-PXXXX command reterence utility (ххххххххххх)
>>
Screen 1 will be displayed.
б
Press СФ )or( +).
Select an emulation.
(НІ!
: Select emulation
[Enter]
: Set emulation
{Е]
: Exit to DOS
Note:
ө You can proceed through the Command Reference program using a computer mouse or your keyboard.
Highlight the desired item and click the left mouse button, or follow the directions on your screen for
keyboard operation.
eThere is a list of proportional spacing tables after the software commands list. If you want to see a
proportional spacing table, select your desired table and press
9
=
D
Ф
О
о
3
3
D
2
о.
Ф
Advertisement
Table of Contents
