Table of Contents
Advertisement
Using the Control Panel
Initial Setup Mode
Тһе following features {items) сап be set in the Initial Setup mode through the Control Panel; Emulation, Auto Line
Feed, Graphic Direction, Page Length and the optional Auto Cut Sheet Feeder (KX-PT12), if installed. These
features can also be set using the Setup Disk (rs Р. 31).
Load a sheet of paper (i P. 19~25), and
turn the power off.
» To enter the Initial Setup mode
While
pressing
|LOAD/PARK |, turn the
power on.
Both FONT indicators and the Super Quiet indicator
will be blinking.
The current settings will be printed automatically.
O
т
2
©
>
o ONLINE. .`
& 6
[FONT]
ша
|ONLINE
:
ја Ó POWER
cr
PAPER OUT
FONT indicators: .,. „"
ET
4
> Selecting the Item
|әцед
1одиод
ош биѕп
FONT indicators
СЭ ON LINE
Press and release | FONT | .
SUPER
T2 QUIET
ON LINE
Each time you press (FONT), you will advance to the
next item. Select the desired item according to the
га POWER
PAPER OUT
54:
де:
status of the FONT indicators (оп, off, blinking).
(ar Р. 49)
4
ON LINE indicator
> Setting the Item's status
dem e
Press and release (ON LINE).
SUPER
|| "от
= сон
The item's status will change each time you press
nim
ON LINE).
|
|
To change the item's status, press (ON LINE).
(89 Р. 49)
To change additional settings, repeat steps 3 and 4.
48
Advertisement
Table of Contents
