JVC RC-828L Service Manual page 6

RC-828L/LB
Disassembly & Replacement
be put out from the slider of switch, when
turning over the circuit board. Check the con-
necting lever, when mounting the circuit board.
SDSP3020RS
=
=
SDSP3006BS
Fig. 14
Tuner Section (Refer to Fig.15)
1. Turn the tuning knob fully counterclockwise.
2. Disconnect 3-pin plug, 5-pin plug, red wire, and black
wire.
Fig. 17
3. Remove 4 screws.
2. Remove 7 screws.
5-pin Plug—= ae
— NY
_— =i °
3-pin Plug—=[]
piack
SPSP3008Z
fs
Fig. 18
Fig. 15
Cassette Mechanism Section (Refer to Fig. 16)
1. Pull up the plastic rivet on the cassette door.
2. Take off 6 slide knobs: REC LEVEL, TONE and
VOLUME controls.
1. Take out the amplifier section.
2. Press 4 projections of chassis to release the circuit board,
and then the circuit board can be turned over.
Fig. 16 Fig. 19
No. 1344