Table of Contents
Advertisement
W Check the parts
Before you begin assembly, check that you have all the following parts.
> Side board (left) ---
od
Side board (right) -
1
a"
Pedal board
og
@
6) Rear board -
sf
®
P
; Side cover --
od
©
y
(@ Long screws (M6 X 60 mm) +-
-8
$ Short screws (M4 X 15 mm) =
"4
I.
@
ss
© Pointed screws (4 X 25 mm)
-4
D
@ Connecting pins
"2
©
@ Philips screwdriver
oT
Cord clamps
72
®© l
E Assembly procedure
Attach the side boards (left and right) to the pedai
board.
Note Extend the pedal cable out from the pedal board,
Note Re sure thot the side boards (left and right ) are oriented correctly: the veneer
surfaces are on the inside.
Note
To prevent the side boards from being damaged when the rear
board is fit to them, temporarily tighten the screws on the
side boards.
g
Attach the side covers.
Note
Be sure that the side covers are oriented correctly:
the rims of the side covers are wider at the back.
@® Use the long screws @ (M6 X 60 mm)
to fasten the side covers to the
*
side boards from the inside.
Pa
(Use two screws for each side.)
ee a
@ Use the long screw @ (M6 X 60 mm) to fasten
the side boards to the pedal board.
(Use two screws for each side.)
To tighten the screws,
slightly lift up the pedal board
so that its threaded holes align
with the holes of the
side boards.
®
Ja
ERE
a
eo
aa
® Affix the cord clamps ® on the appropriate positions at the back of the rear
board (See the figure below.) then fasten
S
the right and left sides should be up.
@ Fit the rear board into position from the front,
as shown in the figure. Then
OA
completely tighten the
screws on the side
boards.
(3) Use the short screws
® (M4 X 15 mm) to
.
fasten the rear board
<q
to the side boards.
(Use two screws for
each side.)
@) Use the pointed screws
© (4 X 25 mm) to fasten the
rear board to the peal hoard. (Use four screws.)
Ey
Attach the piano to the stand.
Note
When placing the piano on the stand, be careful not to pinch your fingers. (Avoid
holding the ends of the piano.)
the peda! cord using the clamps.
4@ Plug the power cord into the rear side of
the piano.
(The power cord is supplied
with the piano.)
N
~
g
Rotate the adjusting bolt.
Note If the piano is placed on carpeting, rotate the adjusting bolt a little more so it is
properly supported by the floor.
Note
When placing the piano in its location, be sure not to pinch the power cord
underneath the piano.
ne
sas
® Align the screws (one on each side) located on ~~"
the bottom of the piano with the holes in the
<
metal fittings, and insert them into the holes.
Slide the piano toward therear so the
screws slide into position.
Va <P
@) insert the connecting
S
f | iN
@ Atter the piano has been assembled
and installed in its location, rotate the
adjusting bolt on the bottom of the
rear board until it completely touches
the floor.
threaded hotes
on the bottom of
the piano through
r
the holes in the
Cia
eel iow
metal fittings of the side boards.
{one on each side}
pins @ into the
[N
©
|
|
Advertisement
Table of Contents
