Table of Contents
Advertisement
Assembling the KS-1800e Stand for the HP-1800e
Two people are needed to carry out the assembly. Never attempt it alone.
* To move the main unit, be sure to keep it level while you lift it straight up.
Be very careful, so as to avoid getting fingers pinched or toes hurt by accidentally dropping the unit.
© Assembly should be carried out by two people.
MCheck the parts
Before you begin assembly, check that you have all the following parts.
® Side board (left)
Side board (right)
© Pedal board-
(© Rear board
Long screws (M6 X 54 mm)
© Short screws (M4 X 27 mm) --
© Pointed screws (4 X 25 mm)
@ Knob bolts
Phillips head screwdriver -
® Cord Clamps iii
WAssembly procedure
Attach the side boards (left and
Bs
ie STA
TT
EE
to -a
a
kapli
board.
Note
Extend the pedal cable out from the pedal board.
Note
Be sure that the side boards (left and right) are
oriented correctly: the metal fittings are on the inside.
lug
in the
pedal cord and the power cor
© Plug the pedal cord into the jacks on the rear side of the piano.
@ Affix the cord clamps © on the appropriate positions at the back of the
rear board (See the figure below.) then fasten the pedal cord using the
clamps.
@ Plug the power cord into the rear side of the piano. (The power cord is
supplied with the piano.)
@ Use the long screws @(M6 x 54 mm) to fasten
the side boards to the pedal board.
(Use two screws for each side.)
2
EY
«—_/{ {=
= |
Attach
/ Attach the rear board. =
rear board.
Note
Be sure that the rear board is oriented correctly: the grainy surface is on
the inside, and the black - painted surface on the outside. The end with two
through holes on the right and left
(Oka
sides should be facing up.
(© Use the short screws ©
(M4 x 27 mm) to
fasten the rear board
to the side boards.
(Use two screws for ©
each side.)
e
@ Use the pointed screws
~"
© (4 x 25 mm) to fasten
the rear board to the
pedal board. (Use four screws.)
g
Attach the piano to the stand.
Note
When placing the piano on the stand. be careful not to pinch your fingers.
(Avoid holding the ends of the piano.)
g
Rotate the adjusting bolt
Note
Ifthe piano is placed on carpeting, rotate the adjusting bolt a little more so
it is properly supported by the floor.
Note
When placing the piano in its location, be sure not to pinch the power cord
underneath the piano.
© After the piano has been assembled and installed in its location, rotate
the adjusting bolt on the bottom of the pedal board until it completely
touches the floor.
@ Align the screws (one on each side)
located on the bottom of the piano
with the slots in the metal fittings,
and slide the piano
toward the front so
the screws
slide into
position.
© Alter the piano is
secured to the
metal fittings,
use the two knob bolts @ to
fasten the piano to the stand. (one on each side)
Advertisement
Table of Contents
