Table of Contents
Advertisement
Available languages
Available languages
Steps
1. Slide the intrusion switch into the slot on the chassis.
2. Route the intrusion-switch cable through the routing guides on the chassis.
3. Connect the intrusion-switch cable to the connector on the system board.
Next steps
1. Install the
side
cover.
2. Follow the procedure in
Ventola di sistema
Removing the system fan
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
3. Remove the
front
bezel.
4. Remove the
2.5-inch hard drive
5. Remove the
3.5-inch hard drive
6. Remove the
disk-drive
About this task
The following image indicates the location of the system fan and provides a visual representation of the removal procedure.
76
Rimozione e installazione di unità sostituibili sul campo (FRU)
After working inside your
Before working inside your
if applicable.
if applicable.
cage.
computer.
computer.
Advertisement
Table of Contents
