Steps
1. Disconnect the system-fan cable from the connector on the system board.
2. Gently pull the top rubber grommets to release the fan from the chassis.
NOTE:
The rubber grommets must be re-used during system fan replacement.
3. Slide and push the bottom rubber grommets through the holes on the chassis.
4. Remove the system fan off the chassis.
Installazione della ventola di sistema
ATTENZIONE:
Le informazioni contenute in questa sezione sono destinate solo ai tecnici di assistenza
autorizzati.
Prerequisiti
Se si sta sostituendo un componente, rimuovere quello esistente prima di eseguire la procedura di installazione.
Informazioni su questa attività
La seguente immagine indica la posizione della ventola di sistema e fornisce una rappresentazione visiva della procedura di
installazione.
Rimozione e installazione di unità sostituibili sul campo (FRU)
77