en - Network connection
Opening the menu
Checking the con-
nection status
56
Switch the cleaning machine on using the button.
You must wait approx. 90 seconds before starting to configure the in-
terface.
Open the menu as follows:
button
Further settings
Interface
Select the
Ethernet
The following options are available:
-
Module status
Displays the connection status.
-
DHCP
The Ethernet interface can either be implemented via a Dynamic
Host Configuration Protocol (DHCP) or by setting the individual
parameters.
Select the
Module status
The following messages may appear in the display:
-
Active
The module is ready for operation.
-
Initialising, module not yet active
The module has not finished initialising. This process takes approx.
90 s.
-
Inactive
No module has been detected.
Check the installation of the module. Switch the cleaning machine
off and then back on again.
If the message continues to appear, contact the Miele Customer
Service Department.
Interface
Ethernet
RS232
interface and confirm your choice with OK.
option and confirm your choice with OK.
Active