Table of Contents
Advertisement
Auxiliary functions can be cancelled or selected in
accordance with the step the program is at. The
door can be opened if the water level is suitable.
Laundry may be added / taken out by opening the
door.
Child-proof lock
This function protects the appliance from being
tampered by children. In this case, all of the
buttons are inactive except On/Off button; by On/
Off button you can whether stop or resume (while
child-lock on) the program of your machine.
The machine is switched to child-lock by pressing
the 1st and 2nd auxiliary functions from the left
for 3 sec. Child-proof lock lamp on the program
follow-up indicator will light up when the child-proof
lock is activated. To deactivate the child-proof lock,
press the same buttons for 3 sec.
Ending the program through
canceling
In order to cancel the selected program, press
the "Start/Pause/Cancel" button for 3 seconds.
You can select and start a new program when the
"Ready" light is lit.
The "Spin" light illuminates if the cancellation
process is activated in the middle of the program
and the machine can either drain all the water or
can take in water 3 times at most to cool down the
clothes and perform the draining process.
The program which is selected first will keep on
going even if the position of the program selection
button is changed. A new program can be
selected or started after "Program is cancelled" in
order to change the washing program.
End of program
The "Ready" lamp on the program follow-up
indicator will light up when the program comes to
an end. The door can be opened and the machine
is ready for a second cycle now. Press the "On/
Off" button to shut down the machine.
5 Maintenance and cleaning
Detergent Drawer
Remove any powder residue buildup in the drawer.
To do this;
1. Press the dotted point on the siphon in the
softener compartment and pull towards you
until the compartment is removed from the
machine.
If more than a normal amount of water and
C
softener mixture starts to gather in the softener
compartment, the siphon must be cleaned.
2. Wash the dispenser drawer and the siphon
with plenty of lukewarm water in a washbasin.
3. Replace the drawer into its housing after
cleaning. Check if the siphon is in its original
location.
Inlet water filters
There is a filter at the end of each water intake
valve at the back side of the machine and also
at the end of each water intake hose where they
are connected to the tap. These filters prevent the
foreign substances and dirt in the water to enter
into the machine. Filters should be cleaned as they
get dirty.
• Close the taps.
• Remove the nuts of the water intake hoses to
clean the surfaces of the filters on the water
intake valves with an appropriate brush.
• If the filters are very dirty, you can pull them out
by means of pliers and clean them.
• Take out the filters on the flat ends of the water
intake hoses together with the gaskets and
clean thoroughly under streaming water.
• Replace the gaskets and filters carefully to their
places and tighten the hose nuts by hand.
Draining any remaining water and
cleaning the pump filter
Your product is equipped with a filter system which
ensures a cleaner water discharge that extends
pump life by preventing solid items such as
9 - EN
Advertisement
Table of Contents
