Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Smeg LAVATRICE LBS-27-9
Summary of Contents for Smeg LAVATRICE LBS-27-9
- Page 1 Washing Machine Lavatrice LBS107-9 LBS127-9...
-
Page 2: Warnings General Safety
1 Warnings General Safety • Never place your machine on a carpet covered floor. Otherwise, lack of airflow from below of your machine may cause electrical parts to overheat. This may cause problems with your washing machine. • If the power cable or mains plug is damaged you must call Authorized Service for repair. • Fit the drain hose into the discharge housing securely to prevent any water leakage and to allow machine to take in and discharge water as required. It is very important that the water intake and drain hoses are not folded, squeezed, or broken when the appliance is pushed into place after it is installed or cleaned. • Your washing machine is designed to continue operating when the power restores after a power interruption. The machine will resume its program when the power restores. Press the “Start/Pause/ Cancel” button for 3 seconds to cancel the program (See, Canceling a Program) • There may be some water in your machine when you receive it. This is from the quality control process and is normal. It is not harmful to your machine. • Some problems you may encounter may be caused by the infrastructure. Press “Start/Pause/Cancel” button for 3 seconds to cancel the program set in your machine before calling the authorized service. -
Page 3: Installation Removing Packaging Reinforcement
2 Installation Removing packaging reinforcement Tilt the machine to remove the packaging reinforcement. Remove the packaging reinforcement by pulling the ribbon. Opening the transportation locks Transportation safety bolts must be removed before operating the washing machine! Otherwise, the machine will be damaged! 1. Loosen all the bolts with a spanner until they rotate freely (“C”) 2. Remove transportation safety bolts by turning them gently. 3. Fit the covers (supplied in the bag with the Operation Manual) into the holes on the rear panel. (“P”) Keep the transportation safety bolts in a safe place to reuse when the washing machine needs to be moved again in the future. Never move the appliance without the transportation safety bolts properly fixed in place! Adjusting the feet Do not use any tools to loosen the lock nuts. Otherwise, they can be damaged. 1. Manually (by hand) loosen the lock nuts on the feet. -
Page 4: Electrical Connection
Electrical connection Connect the machine to an earthed outlet protected by a fuse of suitable capacity. Important: • Connection should comply with national regulations. • The voltage and the allowed fuse protection are specified in the section “Technical Specifications”. • The specified voltage must be equal to your mains voltage. • Connection via extension cords or multi- plugs should not be made. A damaged power cable must be replaced by a qualified electrician. The appliance must not be operated unless it is repaired! There is the risk of electric shock! 3 Initial preparations for washing Preparing clothes for washing Laundry items with metal attachments such as, bras, belt buckles and metal buttons will damage the machine. Remove metal attachments or place the items in a clothing bag, pillow case, or something similar. • Sort the laundry according to type of fabric, color, and degree of soiling and permissible water temperature. Always follow the advice on the garment labels. -
Page 5: Selecting A Program And Operating Your Machine
4 Selecting a Program and Operating Your Machine Control panel 1 - Spin Speed Adjustment Button 2 - Time Delaying Button 3 - Auxiliary Function Keys 4 - Start/Pause/Cancel Button 5 - Program Selection Knob 6 - Display Turning the machine on Plug in your machine. Turn the tap on completely. Check if the hoses are connected tightly. Place the laundry in the machine. Add detergent and softener. Press the “On/Off” button. Program selection Select the appropriate program from the program table and the following washing temperature table according to type, amount and degree of soiling of the laundry. Select the... -
Page 6: Spin Speed Selection
Additional programs may differ according to the model of your machine. • Delicates You can wash your delicate clothes on this program. It has more sensitive washing movements and does not make intermediate spinning compared to “Synthetic” program. • Daily You can use this program to wash cottons and synthetics together. There is no need to sort them. • Eco Synthetics This program is suitable for clothes that are normally worn for a short time such as sportswear. It is used to quickly wash a small amount of cotton/synthetic blended clothes. • Eco This program washes for a longer period at 40°C and gives the same result as the “Cottons 60°C” program, thus it saves energy. It is suitable for clothes for which you cannot use the “Cottons 60°C” program. • Quick This program is used to quickly wash (30 minutes) a small amount of lightly soiled cotton garments. • Intensive Increased hygiene is provided by a longer heating period and an additional rinse cycle. It is recommended for baby clothes and clothes worn by allergic people. • Hand Wash You can wash your woolen/delicate clothes that bear “not machine- washable” labels for which hand wash is recommended on this... -
Page 7: Program And Consumption Table
Program and consumption table Programme Cottons Cottons 60** Cottons Active Intensive Eco Synthetics Sports Synthetics Synthetics Daily Delicate Woollens Hand wash Mini Quick • : Selectable * : Automatically selected, not cancellable. **: Energy Label programme (EN 60456) Water and power consumption and programme duration may differ from the table shown, subject to changes in water pressure, water hardness and temperature, ambient temperature, type and amount of laundry, selection of auxiliary functions, and fluctuations in the supply voltage. “Eco 40” programme may be selected instead of “Cotton 60*” programme during winter in areas where the input water temperature is low and/or in areas with low supply voltage. The auxiliary functions in the table may differ according to the model of your machine. 2.72 1.19 0.78 0.84 1.40 0.40 0.88 0.66 0.38 0.23 0.19 0.18... -
Page 8: Auxiliary Functions
Auxiliary functions Auxiliary Function Selection Buttons Select the required auxiliary functions before starting the program. Some combinations cannot be selected together. (Ex.: Pre-wash and Quick Wash. Warning signal on the selected auxiliary function will light up. Auxiliary function selection If an auxiliary function that should not be selected together with a previously selected function is chosen, the first selected function will be cancelled and the last auxiliary function selection will remain active. (Ex.: If you want to select pre-wash first and then quick wash, pre-wash will be cancelled and quick wash will remain active. Auxiliary function that is not compatible with the program cannot be selected. (see, “Program Selection Table”) Auxiliary function buttons may differ according to the model of your machine. Pre-wash A pre-wash is only worthwhile for heavily soiled laundry. Without pre-wash you save energy, water, detergent and time. Pre-wash without detergent is recommended for lace and curtains. Quick wash This function can be used for “Cottons” and “Synthetics” programs. It decreases the washing times for lightly soiled laundries and also the number of rinsing steps. Rinse Plus With this function, you can increase the number of current rinsing steps. Thus,... -
Page 9: Childproof Lock
automatic spin correction system has been activated due to an excessive unbalanced distribution of laundry in the machine. Changing the selections after the program has started Turning the program knob while the program is in a normal flow will not change the program. Switching the machine to standby mode Press “Start/Pause/Cancel” button momentarily to switch your machine to the standby mode. Auxiliary functions can be cancelled or selected in accordance with the step the program is at. The door can be opened if the water level is suitable. Laundry may be added / taken out by opening the door. Door lock The loading door can not be opened yet due to safety reasons while the “Ready” lamp is flashing. The loading door can be opened once the “Ready” lamp starts lighting up continuously. Child-proof lock You can protect the appliance from being tampered by children by means of the child- proof lock. In this case, no change can be made in the running program. -
Page 10: Cleaning The Pump Filter
Draining any remaining water and cleaning the pump filter Your product is equipped with a filter system which ensures a cleaner water discharge that extends pump life by preventing solid items such as buttons, coins and fabric fibers from clogging the pump propeller during discharge of the washing water. • If your machine fails to drain the water, the pump filter may be clogged. You may have to clean it every 2 years or whenever it is plugged. Water must be drained off to clean the pump filter. In addition, water may have to be drained off completely in the following cases: • before transporting the machine (e.g. when moving house) • when there is the danger of frost In order to clean the dirty filter and discharge the water; 1- Unplug the machine to cut off the supply power. There may be water at 90°C in the machine. Therefore, the filter must be cleaned only after the inside water is cooled down to avoid hazard of scalding. 2- Open the filter cap. The filter cap may be composed of one or two pieces according to the model of your machine. If it is composed of two pieces, press the tab on the filter cap downwards and pull the piece out towards yourself. -
Page 11: Solution Suggestions For Problems
6 Solution suggestions for problems Problem Cause Machine may have switched to self Program cannot protection mode due to be started or an infrastructure problem selected. (such as line voltage, water pressure, etc.). There is water There might be problems coming from with hoses or the pump the bottom of filter. the machine. Machine stopped Machine can stop shortly after temporarily due to low the program voltage. started. It continuously spins. Remaining time There may be an imbalance does not count of laundry in the machine. down. (For models with a display) In the case of a paused countdown while taking in water:... -
Page 12: Specifications
7 Specifications Models Maximum dry laundry capacity (kg) Height (cm) Width (cm) Depth (cm) Net Weight (kg) Electricity (V/Hz.) Total Current (A) Total Power (W) Spinning cycle (rpm max.) Specifications of this appliance may change without notice to improve the quality of the product. Figures in this manual are schematic and may not match your product exactly. Values stated on the machine labels or in the documentation accompanying it are obtained in laboratory in accordance with the relevant standards. Depending on operational and environmental conditions of the appliance, values may vary. This appliance’s packaging material is recyclable. Help recycle it and protect the environment by dropping it off in the municipal receptacles provided for this purpose. Your appliance also contains a great amount of recyclable material. It is marked with this label to indicate the used appliances that should not be mixed with other waste. This way, the appliance recycling organised by your manufacturer will be done under the best possible conditions, in compliance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment. Contact your town hall or your retailer for the used appliance collection points closest to your home. We thank you doing your part to protect the environment. LBS107-9 230 V / 50Hz 2200 1000 12 - EN LBS127-9 230 V / 50hz 2200 1200...