Water Outlet Connection - Smeg LB107-1 Instructions For Use Manual

Water outlet connection

Water outlet connection
Connect the appliance to Connect the appliance to
the mains supply the mains supply
• Fix the outlet hose to run into the sink or the bathtub, or
connect it directly to the wall drain outlet (diameter min. 4 cm).
• Wall drain must be installed properly and must enable
occasional cleaning.
• Fasten the outlet hose support with a piece of rope led through
the hose elbow, to prevent the hose from slipping to the fl oor.
The end of outlet hose should be placed between minimum 60
cm and maximum 100 cm above the fl oor level.
• Plug the mains power cable to the wall mains socket.
• Required voltage and other information are written on the
rating plate above the door opening of the machine.
The wall socket must be accessible at all times and
must be equipped with an earth lead (in accordance
with the local safety regulations).
The permanent connection must be fi tted by an
authorized personnel only.
Damaged mains power cable may be replaced only by
the producer or his authorized personnel.
Never plug the appliance into the electric shaver socket
or hair dryer socket.
If the socket, the machine is connected to, is protected by the
overload protection switch (FID), the nominal differential current
of the switch must be 30 mA (switch mark Idn or I∆n). In case of a
smaller nominal current in the switch, the machine may be switched
off during its normal operation.
7