Smeg LB107 Instructions For Use Manual page 24

Failure
Softener is not
completely rinsed,
or water is left in the
dispenser dish.
Washing time is longer
than usual.
Time indicated on the
display is corrected
during the washing
cycle.
Washing program does
not start.
FAILURE 2
Water does not enter
the machine.
FAILURE 3
Water is poorly
pumped out or not at
all (machine signals
FAILURE 7).
* UKS: universal stability control - this function prevents excessive vibrations during spinning.
24
Possible cause
Sucking cover is not correctly
positioned or is clogged.
• Low temperature of inlet water.
• Due to unevenly distributed
load, the machine has activated
the UKS*.
• Low mains voltage.
• There has been a failure in the
power supply.
• Clean water sensor is engaged.
Door is not properly closed.
Disturbed water inlet.
Water outlet is clogged.
In case you were not successful in repairing the malfunctions in
spite of the above suggestion chart, call the nearest authorized
service shop.
Repairing the failure arising from inappropriate connections or
use of the appliance is not covered by the guarantee, and the
repair expenses are paid by the customer.
Remedy
Clean the dispenser and fi rmly fi x the
cover to its place.
• Washing program time may be up to
60% longer; however, this does not
imply a fault in the machine.
• Washing time is extended by the
power supply down-time.
• Time is prolonged for extra rinses.
Push it towards the machine.
Check if:
• the water faucet is open,
• inlet pipe net fi lter is clean.
(Push the START button again).
Check if:
• the fi lter is clean,
• outlet pipe is not jammed,
• outlet pipe is positioned higher than
1 m.
(Push START knob again).