Troubleshooting - GreenWorks GD60BCB Operator's Manual

8

TROUBLESHOOTING

Problem
The machine does not
start when the trigger is
pushed.
The machine stops
when you are cutting.
The line does not ex-
tend.
English
Possible Cause
No electrical contact between the
machine and the battery pack.
The battery pack is depleted.
The lock-out button and trigger are
not pushed at the same time.
The guard is not attached to the ma-
chine.
Heavy cutting line is used.
The grass winds around the motor
shaft or the trimmer head.
The motor is overloaded.
The battery pack or machine is too
hot.
The battery pack is disconnected
from the tool.
The battery pack is depleted.
Lines are welded to themselves.
Not enough line on the spool.
Lines are worn and too short.
Lines are tangled on the spool.
Solution
1. Remove battery pack.
2. Check contact and install the battery pack
again.
Charge the battery pack.
1. Pull the lock-out button and hold it.
2. Pull the trigger to start the machine.
Remove the battery pack and attach the guard to
the machine.
Use only with the nylon cutting line of 2.0 mm /
2.4 mm diameter.
1. Stop the machine.
2. Remove the battery pack.
3. Remove the grass from the motor shaft and
trimmer head.
1. Remove the trimmer head from the grass.
2. The motor will recover to work as soon as the
load is removed.
3. When you cut, move the trimmer head in and
out of the grass to be cut and remove no more
than 20 cm in pass.
1. Cool the battery pack until its function returns
to normal.
2. Cool the machine for approximately 10 mi-
nutes.
Install the battery pack again.
Charge the battery pack.
Lubricate with silicone spray.
Install more line.
Extend the line.
1. Remove the lines from the spool.
2. Wind the lines.
9
EN