Advertisement
a. Remove the spark plug cap. Clean any dirt from around the spark
plug base, then remove the spark plug.
b. Install the spark plug in the plug cap.
c. Turn the engine switch on.
d. Grounding the side electrode to any engine ground, pull the recoil
starter to see if sparks jump across the gap.
e. If there are no sparks, replace the plug.
If OK, try to start the engine according to the instructions.
8. If the engine still does not start, take the generator to the dealer.
B. When the engine starts but stops immediately;
Is there enough oil in the crankcase?
If not, the engine switch will turn off after starting.
C. No electricity at the AC receptacles:
1. Is the AC circuit breaker on?
2. Check the electrical appliance or equipment for any defects.
D. No electricity at the DC terminals:
1. Is the DC circuit protector on?
2. Check the electrical appliance or equipment for any defects.
27
Advertisement
