Tuner Operation; Tuning; Memorising A Station; Auto Preset Memory/Scan - Sharp PS-955 Operation Manual

Tuner operation

Press the INPUT button repeatedly on the unit until
the display appears FM radio frequency.
Note:
Extend the attached aerial to its full length in order
to get the best reception.
 Tuning
Tune to a station by pressing the
button repeatedly. Press and hold to search
continuously. The station frequency is shown on
the display.
 Memorising a station
Tune in to a desired station, then, press P.MODE/
MEMORY button to save that station.
 Auto preset memory/scan
To scan for stations within reception range and
save them to preset memory automatically, press
and hold the button.
After the unit is fi nished scanning, the unit will
automatically tune to preset number 1 (FM01).
This unit can save up to 30 FM stations.
 To tune to a preset station
To tune to the previous or next preset station, press
the P.MODE/MEMORY

Audio in operation

1.
Press the INPUT button repeatedly until
" " is displayed.
2.
Connect your audio device to the AUDIO IN
terminal on the top panel of the unit with an
audio cable (audio cable is not included).
3.
Rotate the VOLUME knob on the unit or adjust
the volume on the external device to increase
or decrease the music volume to your desired
level.
4.
Control the playback with your audio device.

Line in/out operation

Use the RCA cable to connect your device to the
LINE IN / OUT terminals at the rear panel. Control
the playback with your audio device.
PS-955 _smef_EN_CS4.indd 9 PS-955 _smef_EN_CS4.indd 9
or
or button.
E-9

MIC operation

Microphone input is available in all modes.
Connect your microphone to the 6.3 mm MIC
terminal (1 or 2) located on the top panel of the
unit.
 Microphone volume control
Rotate the MIC VOL 1/2 knob on the unit to
increase or decrease the microphone volume.
 Microphone echo control
Press the ECHO button on the unit repeatedly to
change the microphone echo level.
Note:
This function is available when the microphone is
inserted.
ECHO OFF
ECHO 3
 Key control
While connecting with the microphone, press the
KEY CTRL button and then rotate the volume knob
to adjust the key from: -10 to +10.
ECHO 1
ECHO 2
2023-08-04 17:49:41 2023-08-04 17:49:41