Engine Installation-Gas - Bolens DuraTrac DGT 1800 Service Manual

5100 SERIES
TRACTOR
PAGE 7-6 Rev. 3/92
ENGINE (Continued)
ENGINE INSTALLATION--GASOLINE (Continued)
1 o Position fuel line through heat
shield (I Fig.
7-7)
and connect to
fuel fiHer
(H).
11. Connect starter and solenoid to
cable (J, Fig.
7-8).
NOTE:
Install harness tie securing
cabie to left side of tunnel
(K).
12.
Route main harness into engine
compartment and connect clutch
(F), engine plug (E) and ground
connection
(G)
at intake
manHold.
NOTE:
If unn is equipped with a remote oil
fitter assembly, re-install the oil fitter
base on the unit at this time.
13. Position hood, side panel and
grille assembly over front of
tractor. Place two 1/4"
capscrews Into grille supports at
the Instrument panel support (D,
Fig.
7-7).
Lift front of assembly
and install four 3/8" capscrews
into front engine mount and
bumper
(Q).
Tighten all
hardware.
14. Connect headlight harness to
main harness
(A,
Fig.
7-8),
and ·
secure harness In engine
compartment with cable lies
(B)
in the locations observed at
disassembly.
15. Connect negative battery cable,
open fuel valve at tank and start
unn. Check for smooth
operation of controls, abnormal
sounds, vibrations or fluid leaks.
Check electrical circuits for
proper operation.
Fig. 7-7
/ /
I
--
(clutch---
shown
F
1
_ -/
I
Fig. 7·8
5118H·01
only
)