Engine Removal-Gas - Bolens DuraTrac DGT 1800 Service Manual

1.
2.
3.
4.
5.
6.
7.
ENGINE (Continued)
5100 SERIES
TRACTOR
PAGE 7-3 Rev. 3/92
ENGINE REMOVAL--GASOLINE (Continued)
Open hood. Remove screws
holding side panels. Open side
panels.
Disconnect main wiring harness
from the headlight harness (A,
Fig. 7-1) and cut cable ties
(B)
where attached to grille support.
Remove four (4) 3/8" capscrews
(C)
securing the front bumper to
the frame, and the two (2) 1/4"
screws (D, Fig. 7-2). at the rear of
the grille support at the
instrument panel support.
Remove the grille, side panels
and hood as one assembly.
Disconnect engine electrical
connection plug
(E,
Fig. 7-1 ),
electric clutch connection (F) and
cut related cable ties.
Disconnect small ground wire
connection on intake manifold
(G).
Note routing of harness in
engine compartment and location
of harness ties prior to removal.
Lay harness back on instrument
panel.
Disconnect fuel line at filter
(H,
Fig. 7 -2) and tightly plug open
line and connection. Pull line out
of heat shield (1).
A
CAUTION
HANDLE GASOLINE WITH
CARE- IT iS HIGHLY
FILAMMAIBLIE. MAKE SURE
FUEL LINE IS TIGHTLY
!PLUGGED BEFORE
CONTINUING WITH THIS
RIEIPABR.
--
Fig. 7·1
Fig. 7·2
NOTE:
If unH is equipped with a remote oil
filter assembly, H will be necessary to
unboR fiRer from frame.
8. Disconnect solenoid to starter
cable at solenoid and starter (J,
Fig. 7-1) and cut cable tie (K) at
5118H-Q1
only
tunnel near left rear engine
mount.
9. Remove throttle and choke
control cables from carburetor.
Note original mounting location
and routing for re-assembly. Pull
cables out of heat shield.