Steering Assembly-Power Assist - Bolens DuraTrac DGT 1800 Service Manual

)
CHASSIS (Continued)
5100 SERIES
TRACTOR
PAGE 5·3 Rev. 3/92
STEERING ASSEMBL V (Continued)
(D) into the steering support bracket
(E)
with the steering arm assembly
positioned approximately 15° to the
rear. Add shims and install retaining
ring
(C).
6. Turn steering wheel to check for
binding. Add or remove shims
(Z,
Fig.
5-3),
as needed, for smooth and
proper gear engagement.
7.
Re-install drag links
(B).
8. Re-connect negative(-) battery
cable. ·
SEE PAGE 5-4, FIG. 5-6 FOR AN
EXPLODED VIEW OF THE FRONT
AXLE ASSEMBLY.
STEERING ASSEMBLY (power
assist)
(Fig. 5-5)
NOTE: TO REMOVE THE POWER
STEERING PUMP ONLY, GO TO
STEPS.
The terms right and left hand is
determined by sitting on the tractor
seat facing forward.
1. Open hood and both side panels.
2. Disconnect the battery relay from
the battery support .. Remove battery
and battery support.
3. Remove 3/8" nut and fiat washer
(A) securing steering wheel in place.
Remove steering wheel and woodruff
key (B).
4. Remove locking collar (C) from
steering shalt.
5. Remove drive pin (D) attaching
steering shalt to steering pump (E).
Slide shaft off pump.
6. Disconnect hydraulic lines from
pump.
7. Remove pump form support by
removing four
(4)
hex nuts and lock
washers.
8. Remove pump from tractor.
9. Slide steering shaft down and
out of column, only
n
repair is
necessary.
Fig. 5-5
10. Refer to section 6, page 6-5 of
this manual, HYDRAULIC SYSTEM,
for steering pump and cylinder
information.