Table Of Contents; Engine Cautions - Bolens HUSKY 1476 Operator's Manual

Do not run engine at full throttle to hurry warm-up after
starting, but idle it a few minutes; this will give the oil a
chance to circulate through the engine.
Do not operate the engine at any time with cooling shroud
removed; this will prevent proper cooling of engine.
To prevent overheating of the engine, and / or possible
damage to the engine, check cooling air screen, fan, and
engine cooling fins every 10 hours for debris, dust and dirt
and clean thoroughly. Under severe dust or dirt conditions
the above should be checked and cleaned at more frequent
intervals.
Check and service air cleaner after 10 hours or oftener
under severe dust and dirt conditions. Service air cleaner as
instructed in engine manufacturer's manual. Failure to keep
air cleaner clean would allow abrasive particles to enter the
engine causing severe damage. Also, a dirty air cleaner
would prevent the proper air fuel mixture causing the
engine to overheat and cause consequent damage to the
engine.
After every 8 hours of operation check oil level. For correct
grade of oil and proper oil level, see engine manufacturer's
manual. If the oil in the crankcase is allowed to remain
This is an operational and general maintenance manual only and does not cover major repair. All
major repair work must be performed by an authorized BOLENS DEALER or the factory
warranty is void. Bolens equipment is carefully engineered to give good performance if properly
operated and maintained. Keep your equipment clean and lubricate it as prescribed in this manual.
Periodically inspect your unit and perform any upkeep maintenance necessary. Check for loose or
missing hardware, needed oil or lubrication, damaged parts, etc.
Your dealer is obligated by the factory to completely assemble and service new equipment prior to
first delivery, and thoroughly explain and demonstrate its operation. He will repair or replace any
parts which fail due to defective material and / or workmanship during the warranty period, and
also provide future repair service and supply genuine factory repair parts.
IN EVENT OF ANY PROBLEM OR PARTS REQUIRED ALWAYS CONTACT YOUR DEALER.
DO NOT RETURN PARTS TO THE FACTORY, WE REQUIRE PRIOR FACTORY APPROVAL
ON RETURNS, AND APPROVALS ARE ISSUED ONLY TO BOLENS DEALERS OR
DISTRIBUTORS.
General Safety Precautions ................................... 2
Engine Cautions ................................................... 3
Serial Number ..................................................... 4
Specifications ...................................................... 4
Controls ............................................................... 5
Pre-Operational Checks ........................................ 6
Break-In Period .................................................... 6
Starting The Engine .............................................. 6
Stopping The Engine ............................................ 7
Operation ............................................................. 7
Run-In Period ........................................................ 9
ENGINE CAUTIONS
below the required level, damage to the engine bearings,
cylinder walls, pistons and other moving parts could result
from overheating.
After every 50 hours of operation or oftener under severe
conditions, the engine crankcase should be drained and
refilled with fresh oil.
specifications and quantity of oil.
On units with a gasoline strainer, the strainer should be
inspected frequently. If dirt and water are present in the
bowl, the bowl and screen should be removed and cleaned.
When reassembling strainer be sure gasket is in good
condition; use a new gasket if necessary.
When stopping engine do not stop abruptly, but idle the
engine at low RPM for 3 to 5 minutes. The engine will cool
down faster at idle and minimize the danger of overheating.
SPARK PLUG
The spark plug should be cleaned inside and out and
regapped every 100 hours or once each year whichever
occurs first. Check engine manual for correct gap setting.
Replace plug whenever necessary. See engine manual for
correct plug specifications.
TO THE OWNER
TABLE OF CONTENTS
Page
Preventive Maintenance .....................................................
Adjustments .........................................................................
Lubrication ...........................................................................
Lubrication Chart .................................................................... 13
Minor Troubleshooting
Guide ....................................................................................
Wiring Diagram ...................................................................
Optional Equipment ............................................................
Power Take-Off (P.T.O.) ...................................
Maintenance Guide ..............................................................
Storing Your Husky Tractor................................ 19
See engine manual for proper
Page
9
11
13
15
15
16
17
18
3