Starter Removal And Installation-Gas - Bolens DuraTrac DGT 1800 Service Manual

)
ENGINE (Continued)
5100 SERIES
TRACTOR
PAGE 7-7 Rev. 3192
STARTER REMOVAL AND
INSTALLATION--GASOLINE
A
CAUTION
BEFORE PERFORMING ANY
ENGINE MAINTENANCE ON
YOUR TRACTOR:
a. Disengage PTO drive.
b. Shift tractor into neutral.
c. Set tractor parking brake.
d. Stop tractor engine.
e. Remove key from ignition.
/
/
I
--
(clutch---
shown F __
I
removed)
1 - _/
, I
(~c~F
511BH-Q1
only
f. Disconnect spark plug Fig. 7-9
wire from tractor engine spark
~===================~===~
plug and keep it from touching ,..
spark-plug. ----------
DISCONNECT NEGATIVE
BATTERY CABLE FROM
BATTERY AS WELL BEFORE
ATTEMPTING THIS ENGINE
REMOVAL.
REMOVAL
1. Open hood and remove screws
holding side panels.
2. Disconnect main wiring harness
from the headlight harness (A,
Fig. 7-9) and cut cable ties (B)
where attached to grille support.
3. Remove four 3/8" capscrews
securing the front bumper to the
frame (C), and two 1/4" screws
between the grille supports and
the instrument panel support (D,
Fig.
7-10).
4. Remove the hood, side panels
and grill a as an assembly.
Fig. 7·10
5. Loosen the rear engine mount
botts (T, Fig. 7-10) until the end
of the botts are flush wnh the
nuts.
6. Attach a lift strap under the front
engine mounts and apply tension.
7. Remove the four (4) 3/8"
capscrews (0, Fig. 7-10)
attaching the front engine mount .
plate to the front of the frame
rails.