Page 1
9682121A_oipm_En015_9643581.01 __01-09-2019 Operating Manual & Parts List 9682121A 12" Bench Grinder with stand Read carefully and follow all safety rules and operating instructions before first use of this product. 9643581.01-1118...
• Be alert and think clearly. Never operate power tools when tired, intoxicated or when taking medications that cause drowsiness. Palmgren 12˝ Bench Grinder is equipped with a totally enclosed PREPARE WORK AREA FOR JOB ball bearing motor. Armature assembly is dynamically balanced for •...
Page 3
9682121A_oipm_En015_9643581.01 __01-09-2019 Palmgren Operating Manual & Parts List 9682121A SAFETY RULES (CONTINUED) Mount tool rest assembly to wheel assembly. • Adjust distance between wheel and tool rest to maintain 1/8˝ or 3. Remove hex bolts (H) and flat washers (C) from wheel assembly.
(or green and yellow) wire to a live terminal. POWER SOURCE The Palmgren 12˝ Grinder is prewired for 240 volts, 60 Hz, single- phase power. A qualified electrician should wire a 240 volt, 20 AMP, 3-prong plug to grinder line cord.
• Note the original bevel angle on the item to be sharpened and least 1800 RPM. • Maximum wheel diameter is 12˝ for 9682121A. try to maintain that angle. Sharpening a cutting edge requires • To loosen nuts holding the wheels, disconnect power and push removing burrs from edge.
Page 6
9682121A_oipm_En015_9643581.01 __01-09-2019 Palmgren Operating Manual & Parts List 9682121A...
Page 7
9682121A_oipm_En015_9643581.01 __01-09-2019 Palmgren Operating Manual & Parts List 9682121A...
Page 8
9682121A_oipm_En015_9643581.01 __01-09-2019 Palmgren Operating Manual & Parts List 9682121A Figure 4 – Replacement Parts Illustration for Stand REPLACEMENT PARTS LIST FOR STAND Ref. Description Part Number: Qty. 9604889.01 Column 9624899.00 Base 9624898.00 Water Pot Holder 9624954.00 Water Pot 9624955.00 10-1.5 X 30mm Socket Head Bolt 10-1.5mm Hex Nut...
9682121A_oipm_En015_9643581.01 __01-09-2019 Palmgren Operating Manual & Parts List 9682121A TROUBLESHOOTING SYMPTOM POSSIBLE CAUSE(S) CORRECTIVE ACTION Grinder won’t start 1. Blown line fuse or tripped circuit breaker 1. If fuse is blown, replace with fuse of proper size. If breaker tripped, reset it 2.
Page 10
9682121A_oipm_En015_9643581.01 __01-09-2019 Palmgren Operating Manual & Parts List 9682121A NOTES...
Page 11
9682121A_oipm_En015_9643581.01 __01-09-2019 Palmgren Operating Manual & Parts List 9682121A NOTES...
Page 12
- 3 YEARS. The obligation of C.H. Hanson / Palmgren is limited solely to the repair or replacement, at our option, at its factory or authorized repair agent of any part that should prove inoperable. Purchaser must lubricate and maintain the product under normal operating conditions at all times.