Table of Contents
Advertisement
Before using for the first time
3. Remove the transit bars
Damage resulting from failure to
remove the transit bars.
Failure to remove the transit bars can
result in damage to the washing ma-
chine and to adjacent cabinetry or
appliances.
Remove the transit bars as described
in "Installation and connection".
The following message appears in the
display:
Remove transit bars
Confirm with the OK sensor control.
4. Commissioning TwinDos
The UltraPhase 1 and UltraPhase 2 val-
ues are preset in the standard settings
and only need to be confirmed.
The following message appears in the
display:
TwinDos
Confirm with the OK sensor control.
The following message appears in the
display:
Set now
To set up TwinDos now, touch the OK
sensor control.
To postpone setup until later: touch
the sensor control until the follow-
ing appears in the display:
and press OK to confirm.
20
Settings for compartment
The UltraPhase 1 values are preset in
the standard settings.
Confirm with the OK sensor control.
Miele UltraPhase 1
Confirm with the OK sensor control.
The following appears in the display:
Set the dosage. Observe water hardness
levels
Confirm with the OK sensor control.
The dispensing quantity for UltraPhase 1
is preset for (hardness level II).
Per load
Confirm the preset value with the
OK sensor control. If you want to
change this value, use the sensor
controls and confirm with the OK
sensor control.
Set later
Agent for
UltraPhase 1
Hardness level I
Hardness level II
Hardness level III
OK
OK
58
ml
OK
46 ml
58 ml
70 ml
Advertisement
Table of Contents
