Information about the batteries
1) This handheld vacuum cleaner is powered by rechargeable lithium-ion batteries .
2) For care of the batteries, we recommend the following: Once the batteries
have been charged, disconnect the mains adapter 4 from the mains socket .
Do not reconnect the mains adapter 4 with the mains socket until the hand-
held vacuum cleaner's suction power has noticeably decreased .
Installation of the wall bracket
DANGER – ELECTRIC SHOCK!
►
Ensure that there are no power cables or other conduits or pipes in the wall
at the location where you intend to bore the holes for the wall bracket 3 .
Drilling into a current-carrying electric cable can be potentially fatal!
1) Place the barrel plug 5 of the mains adapter 4 into the wall bracket 3 as
shown in the diagram . Secure the barrel plug 5 by turning it .
2) Select a suitable installation location for the wall bracket 3:
It must be possible to remove the handheld vacuum cleaner easily and there
must be an accessible mains power socket for the mains adapter 4 .
3) Drill two holes about 61 mm apart . Use the wall bracket 3 to mark the holes,
to ensure the correct spacing . The drill holes must be suitable for 5 mm wall
plugs .
4) Push the wall plugs r into the holes and then screw the wall bracket 3
firmly into place using the screws e .
5) You can place the nozzles on the accessories holder on the side .
6) Connect the mains adapter 4 to a mains power socket .
SAS 7.4 LI B3
GB │ MT
│
31
■