2.
Fix the base to the arm by fastening the bundled screw. (Figure 2)
3.
Lift the cover to expose the VESA area for stand assembly. (Figure 3 in next
page)
4.
Attach the stand into the back of the monitor, making sure the tab on the arm
fits into the groove on the back of the monitor. (Figure 4 in next page)
5.
Place the monitor upright. (Figure 5 in next page)
Do not press on the screen when lifting the monitor. Lift the monitor carefully to
prevent it from slipping or falling.
6.
Remove the cover from the monitor. (Figure 6 in next page)
Base screw size: M6 x 19 mm.
2-2
(Figure 2)
Chapter 2: Setup