Vertex Standard VX-1700 Series Service Manual page 44

CE77 PC Programming Software
SILENT MODE
This parameter defines whether the Silent mode
shall be "Enabled (SILENT)" or "Disabled (NOR-
MAL)."
When this parameter is set to "Enabled (SI-
LENT)," the network can initiate calls but the net-
work is not allowed to respond to an ALE trans-
mission.
SCAN RATE
This parameter toggles the scan speed between
the "2 sec/ch" (2 seconds per channel) and "5 sec/
ch" (5 seconds per channel) when the radio is in
the ALE mode.
We recommend that this parameter is set to "2
sec/ch" when the ALE Unit and Antenna Tuner
Unit is used simultaneously.
TUNE TIME
This parameter sets the maximum time that the
current ALE will wait for the called station to re-
spond.
The available selections are "1 Sec" to "20 Sec,"
and "OFF (0 Sec)." However, please set this pa-
rameter to "OFF (0 Sec)" at all times.
NET NUMBER
This pull-down list selects the Network number
to be programmed.
44
AUTO DIAL PARAMETER
This parameter programs the address and message
for the ALE Call.
To enter the address, double click the left mouse
button on the desired "Address" to invoke a pop-up
window, select the desired address, then click the
[OK] button to accept the address.
To enter the message, if you desired, select the Net-
work Member to be programmed from the pull-
down list, then double click the left mouse button
on the desired "Message" to invoke a pop-up win-
dow, select the desired message, then click the [OK]
button to accept the message.
Put a check mark into the check box to enable ad-
justment of its parameter from the transceiver's set
("menu") mode.
"A D " P
UTO IAL ARAMETERS
VX-1700 Series (EXP Version) Service Manual