Table of Contents
Advertisement
Since you
know
the voltage to be measured
is small,
set the 3468A
to a low
range before we autorange. The instruction "R2"
will do this. Furthermore, if we
want the meter to only take one reading, add the instruction "T2"
to the end of
the string. By adding it at the end, the meter is set up for the measurement before
the reading is actually triggered.
The complete
string, along with the OUTPUT
statement is:
OUTPUT
901; "F2R1RAZ1N4T2"
Instructions
are
implemented
as
they
are
received
through
the
loop.
In other
words, the 3468A
will go to the ac volts mode
before it goes to the lowest
range. It will go to the lowest range before autorange, etc. The last thing it will do
is trigger for the measurement.
Programming
Hints
When more than one command
is sent to the 3468A in one "OUTPUT"
instruc-
tion statement, the commands are executed as they arrive. Therefore it is best to
make the trigger statement the last statement in the command
string so that the
3468A will be set up for the measurement before it triggers. If you send the com-
mand "T2T1", the "T1"
command
is the last one received and will be in effect.
Instructions are sent to the 3468A as a series of 8-bit ASCII characters. All lower-
case letters, spaces, commas,
semicolons, Carriage Return (CR) and Line Feed (LF)
are ignored and may be freely used to format commands for easy readability. All
null characters, form feed, and vertical and horizontal tab characters result in a
syntax errror. All other characters and sequences
not explicitly allowed
(see the
Command
Table) also result in a syntax error. Errors will be discussed later. For
example,
sending the message:
OUTPUT
901;"Function
1 Range
1"
would be the same as:
OUTPUT
901;"F1R1"
When a multicharacter command
is received, if a character is received which does
not fit into the syntax of the command,
the command
will be aborted and an error
will be generated. An attempt is made to process the character as if it were the
first character of another command.
For example, the command
"FR3"
will cause
a syntax error but then go on to range 3 (that is, ""R3").
66
Uj
Advertisement
Table of Contents
