Advertisement
OptiXstar B866G-P1 Quick Start
How do I log in to the WebUI?
Step 1 Set the IP address of the PC in the same network segment as the management IP address (for
details, see the product nameplate) of the ONU.
Step 2 Enter the management IP address of the ONU in the address box and press Enter. The login
page is displayed.
Step 3 On the login page, enter the user name and password (for details, see the product nameplate),
and click Login. After the password is authenticated, the web page is displayed.
----End
How do I set the network for a sub FTTR?
After being connected to an FTTR network, a sub FTTR automatically synchronizes network
settings from the main FTTR, and does not need to be configured.
How do I change the Wi-Fi name and password of the device?
In the FTTR for SME solution, it is recommended that the Wi-Fi name and password be
changed on the main FTTR. The changes are automatically synchronized to sub FTTRs.
How to restart B866G-P1?
Press RESET button for a short time to restart the device.
How to restore the B866G-P1 to factory setting?
Press RESET button with a needle for longer than 10 seconds to restore factory defaults and
reset the B866G-P1. If the indicator is off and then is lit, the system restores successfully.
Issue 03 (2024-01-25)
If you do not perform any operations after logging in to the system within five minutes,
you will be logged out and the system automatically returns to the login web page.
The system will be locked if you input incorrect user names and passwords for three
consecutive times. One minute later, it will be unlocked.
Change the initial password after logging in to the web page.
Copyright © Huawei Technologies Co., Ltd.
8 FAQs
8
FAQs
14
Advertisement
